CP3UB17G38 NSC [National Semiconductor], CP3UB17G38 Datasheet - Page 139

• Manufacturer Part Number: CP3UB17G38
• Description: CP3UB17 Reprogrammable Connectivity Processor with USB Interface
• Manufacturer: NSC [National Semiconductor]

22.2.3
Mode 3 is the Dual Independent Timer mode, which gener-
ates system timing signals or counts occurrences of exter-
nal events.
Timer/Counter 1 (TCNT1) counts down at the rate of the se-
lected clock. On underflow, it is reloaded from the TCRA
register and counting proceeds down from the reloaded val-
ue. In addition, the TA pin is toggled on each underflow if this
function is enabled by the TAEN bit. The initial state of the
TA pin is software-programmable. When the TA pin is tog-
gled from low to high, it sets the TCPND interrupt pending
bit and also generates an interrupt if enabled by the TAIEN
bit.
Because the TA pin toggles on every underflow, a 50% duty
cycle PWM signal can be generated on the TA pin without
any further action from the CPU.
Mode 3: Dual Independent Timer/Counter
Timer 1
Timer 2
Clock
Clock
Figure 49. Dual-Independent Timer/Counter Mode
Timer/Counter 1
Timer/Counter 2
Reload A
Reload B
TCNT1
TCNT2
TCRA
TCRB
Underflow
Underflow
139
Figure 49 is a block diagram of the Multi-Function Timer
configured to operate in Mode 3. The timer is configured to
operate as a dual independent system timer or dual external
event counter. In addition, Timer/Counter 1 can generate a
50% duty cycle PWM signal on the TA pin.
Timer/Counter 2 (TCNT2) counts down at the rate of the se-
lected clock. On underflow, it is reloaded from the TCRB
register and counting proceeds down from the reloaded val-
ue. In addition, each underflow sets the TDPND interrupt
pending bit and generates an interrupt if the interrupt is en-
abled by the TDIEN bit.
TDPND
TAPND
TDIEN
TAIEN
TAEN
Timer
Interrupt 1
Timer
Interrupt 2
DS168
TA
www.national.com