MC68HC08AZ60CFU MOTOROLA [Motorola, Inc], MC68HC08AZ60CFU Datasheet - Page 58

• Manufacturer Part Number: MC68HC08AZ60CFU
• Description: Advance Information
• Manufacturer: MOTOROLA [Motorola, Inc]

EEPROM-2
EEPROM Block
Protection
MC68HC08AZ60 — Rev 1.0
58
All bits should be erased before being programmed.
The 512 bytes of EEPROM are divided into four 128-byte blocks. Each
of these blocks can be separately protected by EEBPx bit. Any attempt
to program or erase memory locations within the protected block will not
allow the program/erase voltage to be applied to the array.
shows the address ranges within the blocks.
If EEBPx bit is set, that corresponding address block is protected. These
bits are effective after a reset or a read to EENVR2 register. The block
protect configuration can be modified by erasing/programming the
corresponding bits in the EENVR2 register and then reading the
EENVR2 register.
Freescale Semiconductor, Inc.
For More Information On This Product,
c. Any attempt to clear both EEPGM and EELAT bits with a
mode cannot be modified. If EEPGM is set, the onboard
charge pump generates the erase voltage and applies it to the
user EEPROM array. When the EEPGM bit is cleared, the
erase voltage is removed from the array and the internal
charge pump is turned off.
single instruction will only clear EEPGM. This is to allow time
for removal of high voltage from the EEPROM array.
Block Number (EEBPx)
Go to: www.freescale.com
Table 1. EEPROM Array Address Blocks
EEBP0
EEBP1
EEBP2
EEBP3
EEPROM-2
Address Range
$0600–$067F
$0680–$06FF
$0700–$077F
$0780–$07FF
Table 1
MOTOROLA
6-eeprom-2