TLE6230 INFINEON [Infineon Technologies AG], TLE6230 Datasheet - Page 10
![no-image](/images/no-image-200.jpg)
TLE6230
Manufacturer Part Number
TLE6230
Description
Smart Octal Low-Side Switch?
Manufacturer
INFINEON [Infineon Technologies AG]
Datasheet
1.TLE6230.pdf
(16 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
TLE6230 GP
Manufacturer:
INFINEON
Quantity:
25
Company:
Part Number:
TLE62300R
Manufacturer:
INFINEON
Quantity:
8 831
Company:
Part Number:
TLE6230GP
Manufacturer:
INFINEON
Quantity:
1 210
Company:
Part Number:
TLE6230GP
Manufacturer:
INFINEON
Quantity:
804
Part Number:
TLE6230GP
Manufacturer:
INFINEON/英飞凌
Quantity:
20 000
Part Number:
TLE6230R
Manufacturer:
INFINEON/英飞凌
Quantity:
20 000
A definite distinction between open load and short to ground is guaranteed by design.
The standard way of obtaining diagnostic information is as follows:
Clock in serial information into SI pin and wait approximately 150 µs to allow the outputs to-
settle. Clock in the identical serial information once again - during this process the data com-
ing out at SO contains the bit combinations representing the diagnosis conditions as described
in figure 1.
By means of the control byte it is possible either to:
a) Serial Control of Outputs
Control byte is set to FFhex: Data byte will be accepted. The outputs will be switched ON or
OFF according to the information of the data byte and the parallel inputs (Channel 1 to 4 be-
cause of AND operation).
All other control words except the one for 'Diagnosis Only = 00hex' will also be accepted as a
valid control word and the data will be accepted.
Example: HLLHLHLH DDDDDDDD: Outputs will switch according to the data bits.
b) Diagnosis Only
Control byte is set to 00hex: Data byte will be ignored. Diagnostic information can be read out
at any time with no change of the switching conditions. Only 00hex means 'Diagnosis Only'.
V2.1
HHHHHHHH LHLHHLLL
LLLLLLLL XXXXXXXX
" "
" "
Control Byte
or b) purely get diagnostic information without changing the state of the outputs.
Control Byte
a) control the eight outputs according to the data byte, as well as being able to read the
" " " "
"" " "
diagnostic information
!
!
Data Byte
Data Byte
""
""
!
!
: Serial input information
: Serial input information
Page
10
Data Sheet TLE 6230 GP
26. Aug. 2002