PEB3086 Infineon Technologies, PEB3086 Datasheet - Page 204
PEB3086
Manufacturer Part Number
PEB3086
Description
ISDN Subscriber Access Controller
Manufacturer
Infineon Technologies
Datasheet
1.PEB3086.pdf
(262 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
PEB3086F
Manufacturer:
INFINEON
Quantity:
85
Company:
Part Number:
PEB3086F
Manufacturer:
HARRIS
Quantity:
104
Company:
Part Number:
PEB3086FV1.4
Manufacturer:
INFINEON
Quantity:
183
Part Number:
PEB3086FV1.4
Manufacturer:
INFINEON/英飞凌
Quantity:
20 000
Company:
Part Number:
PEB3086FV14
Manufacturer:
RENESAS
Quantity:
2 720
Company:
Part Number:
PEB3086H
Manufacturer:
INFINEON
Quantity:
9
Part Number:
PEB3086H-V1-4
Manufacturer:
INFINEON/英飞凌
Quantity:
20 000
Part Number:
PEB3086HV1.4
Manufacturer:
INFINEON/英飞凌
Quantity:
20 000
ISAC-SX
PEB 3086
Detailed Register Description
EN_BCL ... Enable Bit Clock BCL/SCLK
0: The BCL/SCLK clock is disabled
1: The BCL/SCLK clock is enabled.
CLKM ... Clock Mode
If the transceiver is disabled (DIS_TR = ’1’) or in NT, LT-S and Int. NT mode the DCL
from the IOM-2 interface is an input.
0: A double bit clock is connected to DCL
1: A single bit clock is connected to DCL
For general information please refer to
Chapter
3.7.
DIS_OD ... Disable Open Drain Drivers
0: DU/DD are open drain drivers
1: DU/DD are push pull drivers
DIS_IOM ... Disable IOM
DIS_IOM should be set to ’1’ if external devices connected to the IOM interface should
be “disconnected“ e.g. for power saving purposes or for not disturbing the internal IOM
connection between layer 1 and layer 2. However, the ISAC-SX internal operation
between S-transceiver, B-channel and D-channel controller is independent of the
DIS_IOM bit.
0: The IOM interface is enabled
1: The IOM interface is disabled. The FSC, DCL clock outputs have high impedance;
clock inputs are active; DU, DD data line inputs are switched off and outputs have high
impedance; except in TE/LT-T mode the DU line is input (’0’-level causes activation), so
the DU pin must be terminated (pull up resistor).
Data Sheet
204
2003-01-30