SX-550-1701 Silex Technology, SX-550-1701 Datasheet - Page 38

• Manufacturer Part Number: SX-550-1701
• Description: WiFi / 802.11 Modules & Development Tools 802.11a/b/g Bridge Serial Server
• Manufacturer: Silex Technology

Specifications of SX-550-1701

• Interface Type: UART
• Board Size: 59.6 mm x 49.1 mm x 14.3 mm
• Security: 802.1xEAP, PEAP, WEP, WPAPSK, TKIP, WPA2, AES
• Operating Voltage: 3.3 VDC
• Operating Temperature Range: 0 C to + 50 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Part Number 40183-101
2. When the SX-550 is powered on, you will see some information about the firmware versions and
3. Enter the basic wireless settings as follows:
4. Use the appropriate SET NW command to set wireless encryption mode and authentication type
5. To set the serial port, enter the following commands:
copyright notices displayed on the terminal. When you see the Local> prompt, you can enter
commands. The SX-550 is set by default to use DHCP to obtain the IP address automatically. If
you want to set the IP address manually, enter the following commands:
where aa.bb.cc.dd is the IP address of the SX-550. You can use the command SHOW IP to
verify the IP address settings.
(check with your network administrator for the proper settings if you do not know them):
For WPA2-PSK or WPA, enter the command:
For WEP (WEP64 or WEP128), use the following commands:
Configuring 802.1X EAP authentication can be complex. Please refer to Appendix A and/or
Appendix B for details of the required commands.
SET IP ADDRESS aa.bb.cc.dd
SET IP SUBNET aa.bb.cc.dd
SET IP ROUTER aa.bb.cc.dd
SET NW SSID <name>
SET NW MODE <mode>
SET NW CHANNEL n
SET NW ENC <mode>
SET NW AUTHTYPE <type>
SET NW WPAPSK <psk>
SET NW WPAGROUP <state> [enables or disables WPA group key mode, where
SET NW KEYVAL <key>
SET NW KEY# n
SET PORT S1 SPEED <baudrate>
SET PORT S1 PARITY <parity>
SET PORT S1 SIZE <databits>
[sets the number of the WEP key that will be used as the
Silex SX-550 Developer's Guide
AD-HOC]
AD-HOC MODE]
[sets encryption mode, where <mode> is WPA, WPA2,
[sets authentication type, where <type> is OPEN,
[sets pre-shared key for WPA2 or WPA, where <psk> is
[Sets WEP key, where <key> is 10 hex characters for
[where <name> is the SSID for your network]
[where mode is INFRASTRUCTURE or
[where n is 1 to 11; this is only required for
64, 128, or WPA2-WPA]
SHARED, TTLS, PEAP, WPA-PSK, LEAP, TLS,
or FAST].
the key]
<state> is ENABLED or DISABLED; default is
DISABLED]
WEP64 or 26 hex characters for WEP128]
transmit key, where n=1 to 4; default value is 1]
[where <baudrate> is 300 to 921600]
[where <parity> is ODD, EVEN, MARK, or
SPACE]
[where <databits> is 7 or 8]
Page 30