SX-550-1701 Silex Technology, SX-550-1701 Datasheet - Page 80

• Manufacturer Part Number: SX-550-1701
• Description: WiFi / 802.11 Modules & Development Tools 802.11a/b/g Bridge Serial Server
• Manufacturer: Silex Technology

Specifications of SX-550-1701

• Interface Type: UART
• Board Size: 59.6 mm x 49.1 mm x 14.3 mm
• Security: 802.1xEAP, PEAP, WEP, WPAPSK, TKIP, WPA2, AES
• Operating Voltage: 3.3 VDC
• Operating Temperature Range: 0 C to + 50 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Echo control
Disconnect
Return to data mode
Quiet mode
Verbose mode
Console pass through
Console Quiet mode
Part Number 40183-101
Parameter
Parameter
Table 30 Extended AT Commands
ATEn
ATHn
ATOn
ATQn
ATVn
AT#C<string>
AT#Qn
Command
Command
Silex SX-550 Developer's Guide
If n=0, commands are not echoed.
If n=1, subsequent commands will be echoed.
The default, upon unit reset, is for no echo (ATE0).
If n=0, any connection to a remote host is dropped.
Other value of n is ignored.
Exits command mode and places the serial port in the
data mode.
All subsequent data is sent to the network
application, if connected, until an enter command
mode sequence is received. Any value of n is
ignored, if present.
If n = 1, no result codes are returned.
If n = 0, result codes are returned to the local device.
0 is the reset default value.
If n = 0 and not in quiet mode, result codes are
returned in numerical form.
If n = 1, results are returned as text. 1 is the reset
default value.
Passes the string to the server configuration console.
The string can be any valid console command. Refer
to your server documentation for console commands
available on your unit.
Since this command does not follow the normal AT
command format of <command><number>, it must
be the last command on the line unless the next
command is a '#' command. All characters up to the
end of line or a '# will be considered part of the
console command.
If console quiet mode is not is enabled, then the
response will be the standard console task response.
Example:
If n = 0, a response to a #C command is given.
after reset is 1.
If n = 1, the response is not provided. The default
AT#Cset nw ssid silex#Csave
Description
Description
Page 72