M25PX32-VMF6E NUMONYX, M25PX32-VMF6E Datasheet - Page 27

• Manufacturer Part Number: M25PX32-VMF6E
• Manufacturer: NUMONYX

Specifications of M25PX32-VMF6E

• Cell Type: NOR
• Density: 32Mb
• Access Time (max): 8ns
• Interface Type: Serial (SPI)
• Boot Type: Not Required
• Address Bus: 1b
• Operating Supply Voltage (typ): 3.3V
• Operating Temp Range: -40C to 85C
• Package Type: SOIC W
• Sync/async: Synchronous
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (min): 2.7V
• Operating Supply Voltage (max): 3.6V
• Word Size: 8b
• Number Of Words: 4M
• Supply Current: 12mA
• Mounting: Surface Mount
• Pin Count: 16
• Lead Free Status / RoHS Status: Compliant

6.3
Table 6.
Manufacturer identification
Read Identification (RDID)
The Read Identification (RDID) instruction allows to read the device identification data:
•
•
•
The manufacturer identification is assigned by JEDEC, and has the value 20h. The device
identification is assigned by the device manufacturer, and indicates the memory type in the
first byte (71h), and the memory capacity of the device in the second byte (16h). The UID
contains the length of the following data in the first byte (set to 10h) and 16 bytes of the
optional Customized Factory Data (CFD) content. The CFD bytes are read-only and can be
programmed with customers data upon their demand. If the customers do not make
requests, the devices are shipped with all the CFD bytes programmed to zero (00h).
Any Read Identification (RDID) instruction while an Erase or Program cycle is in progress, is
not decoded, and has no effect on the cycle that is in progress.
The Read Identification (RDID) instruction should not be issued while the device is in Deep
Power-down mode.
The device is first selected by driving Chip Select (S) Low. Then, the 8-bit instruction code
for the instruction is shifted in. After this, the 24-bit device identification, stored in the
memory, the 8-bit CFD length followed by 16 bytes of CFD content will be shifted out on
Serial Data output (DQ1). Each bit is shifted out during the falling edge of Serial Clock (C).
The instruction sequence is shown in
The Read Identification (RDID) instruction is terminated by driving Chip Select (S) High at
any time during data output.
When Chip Select (S) is driven High, the device is put in the Standby Power mode. Once in
the Standby Power mode, the device waits to be selected, so that it can receive, decode and
execute instructions.
Read Identification (RDID) data-out sequence
20h
Manufacturer identification (1 byte)
Device identification (2 bytes)
A Unique ID code (UID) (17 bytes, of which 16 available upon customer request).
Memory type
71h
Device identification
Memory capacity
Figure
16h
11.
CFD length
10h
UID
CFD content
16 bytes
27/68