NAND08GW3C2A NUMONYX [Numonyx B.V], NAND08GW3C2A Datasheet - Page 7

• Manufacturer Part Number: NAND08GW3C2A
• Description: 8/16 Gbit, 2112 byte page, 3 V supply, multilevel, multiplane, NAND Flash memory
• Manufacturer: NUMONYX [Numonyx B.V]

NAND08GW3C2A, NAND16GW3C2A
1
Description
The NAND08GW3C2A and NAND16GW3C2A are multilevel cell (MLC) devices from the
NAND Flash 2112-byte page family of non-volatile Flash memories. The NAND08GW3C2A
and the NAND16GW3C2A have a density of 8- and 16-Gbit, respectively. The
NAND16GW3C2A is composed of two 8-Gbit dice; each die can be accessed independently
using two Chip Enable and two Ready/Busy signals. The devices operate from a 3 V VDD
power supply.
The address lines are multiplexed with the Data Input/Output signals on a multiplexed x8
input/output bus. This interface reduces the pin count and makes it possible to migrate to
other densities without changing the footprint.
Each block can be programmed and erased over 10,000 cycles (with ECC on). The device
also has hardware security features; a write protect pin is available to give hardware
protection against Program and Erase operations.
The devices feature an open-drain, ready/busy output that can be used to identify if the
Program/Erase/Read (P/E/R) Controller is currently active. The use of an open-drain output
allows the ready/busy pins of several memories to be connected to a single pull-up resistor.
The memory array is split into 2 planes of 2048 blocks each. This multiplane architecture
makes it possible to program 2 pages at a time (one in each plane) or to erase 2 blocks at a
time (one in each plane), dividing by two the average program and erase times.
The devices have the Chip Enable “Don’t Care” feature, which allows code to be directly
downloaded by a microcontroller, as Chip Enable transitions during the latency time do not
stop the Read operation.
There is the option of a unique identifier (serial number), which allows the
NAND08GW3C2A and the NAND16GW3C2A to be uniquely identified. It is subject to an
NDA (non-disclosure agreement) and is, therefore, not described in the datasheet. For more
details of this option contact your nearest Numonyx Sales office.
The devices are available in TSOP48 (12 × 20 mm) and LGA52 (12 x 17 x 0.65 mm)
packages. To meet environmental requirements, Numonyx offers the devices in ECOPACK
packages. ECOPACK packages are lead-free. In compliance with JEDEC Standard
JESD97, the category of second level interconnect is marked on the package and on the
inner box label. The maximum ratings related to soldering conditions are also marked on the
inner box label.
The devices are shipped from the factory with block 0 always valid and the memory content
bits, in valid blocks, erased to ‘1’.
Refer to the list of available part numbers and to
information on how to order these options.
Table 24: Ordering information scheme
Description
7/58
for
®