SAK-C505L Infineon Technologies AG, SAK-C505L Datasheet - Page 69

• Manufacturer Part Number: SAK-C505L
• Description: 8-bit CMOS Microcontroller
• Manufacturer: Infineon Technologies AG

Notes:
1)
2) During the sample time the input capacitance
3) This parameter includes the sample time
4)
5) During the conversion the ADC’s capacitance must be repeatedly charged or discharged. The internal
6) Not 100% tested, but guaranteed by design characterization.
Data Sheet
V
cases will be X000
internal resistance of the analog source must allow the capacitance to reach their final voltage level within
After the end of the sample time
calibration. Values for the conversion clock
the previous page.
T
voltages within the defined voltage range.
If an overload condition occurs on maximum 2 unused analog input pins and the absolute sum of input
overload currents on all analog input pins does not exceed 10 mA, an additional conversion error of 1/2 LSB
is permissible.
resistance of the reference source must allow the capacitance to reach their final voltage level within the
indicated time. The maximum internal resistance results from the programmed conversion timing.
UE
AIN
is tested at
may exceed
V
AREF
V
H
AGND
or X3FF
= 5.0 V,
or
V
AREF
H
V
, respectively.
AGND
t
S
up to the absolute maximum ratings. However, the conversion result in these
, changes of the analog input voltage have no effect on the conversion result.
= 0 V,
V
t
S
t
DD
, the time for determining the digital result and the time for the
ADC
C
= 4.9 V. It is guaranteed by design characterization for all other
AIN
depend on programming and can be taken from the table on
must be charged/discharged by the external source. The
67
C505L
06.99
t
S
.