S9S12GA192F0MLHR Freescale Semiconductor, S9S12GA192F0MLHR Datasheet - Page 1018

• Manufacturer Part Number: S9S12GA192F0MLHR
• Description: 16-bit Microcontrollers - MCU 16BIT192KFLASH 11264 RAM
• Manufacturer: Freescale Semiconductor

Specifications of S9S12GA192F0MLHR

• Rohs: yes
• Core: S12
• Processor Series: MC9S12G
• Data Bus Width: 16 bit
• Maximum Clock Frequency: 25 MHz
• Program Memory Size: 192 KB
• Data Ram Size: 2 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 3.13 V to 5.5 V
• Operating Temperature Range: - 40 C to + 125 C
• Package / Case: LQFP-64
• Mounting Style: SMD/SMT

96 KByte Flash Module (S12FTMRG96K1V1)
Upon clearing CCIF to launch the Program P-Flash command, the Memory Controller will program the
data words to the supplied global address and will then proceed to verify the data words read back as
expected. The CCIF flag will set after the Program P-Flash operation has completed.
28.4.6.6
The Program Once command restricts programming to a reserved 64 byte field (8 phrases) in the
nonvolatile information register located in P-Flash. The Program Once reserved field can be read using the
Read Once command as described in
once since the nonvolatile information register in P-Flash cannot be erased. The Program Once command
must not be executed from the Flash block containing the Program Once reserved field to avoid code
runaway.
Upon clearing CCIF to launch the Program Once command, the Memory Controller first verifies that the
selected phrase is erased. If erased, then the selected phrase will be programmed and then verified with
read back. The CCIF flag will remain clear, setting only after the Program Once operation has completed.
1020
1
As defined by the memory map for FTMRG96K1.
Register
FSTAT
Program Once Command
1
CCOBIX[2:0]
Global address [2:0] must be 000
MGSTAT1
MGSTAT0
ACCERR
Error Bit
Table 28-42. Program Once Command FCCOB Requirements
FPVIOL
000
001
010
011
100
101
Table 28-41. Program P-Flash Command Error Handling
MC9S12G Family Reference Manual,
Set if CCOBIX[2:0] != 101 at command launch
Set if command not available in current mode (see
Set if an invalid global address [17:0] is supplied see
Set if a misaligned phrase address is supplied (global address [2:0] != 000)
Set if the global address [17:0] points to a protected area
Set if any errors have been encountered during the verify operation
Set if any non-correctable errors have been encountered during the verify
operation
Section
Program Once phrase index (0x0000 - 0x0007)
0x07
28.4.6.4. The Program Once command must only be issued
Program Once word 0 value
Program Once word 1 value
Program Once word 2 value
Program Once word 3 value
FCCOB Parameters
Error Condition
Rev.1.23
Not Required
Table
Table
28-27)
28-3)
Freescale Semiconductor
1