S9S12G64F0CLFR Freescale Semiconductor, S9S12G64F0CLFR Datasheet - Page 1124

• Manufacturer Part Number: S9S12G64F0CLFR
• Description: 16-bit Microcontrollers - MCU S12 Core,64K FLASH AU
• Manufacturer: Freescale Semiconductor

Specifications of S9S12G64F0CLFR

• Rohs: yes
• Core: S12
• Processor Series: MC9S12G
• Data Bus Width: 16 bit
• Maximum Clock Frequency: 1 MHz
• Program Memory Size: 64 KB
• Data Ram Size: 8 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 3.13 V to 5.5 V
• Operating Temperature Range: - 40 C to + 125 C
• Package / Case: LQFP-48
• Mounting Style: SMD/SMT
• A/d Bit Size: 10 bit, 12 bit
• A/d Channels Available: 12
• Interface Type: SPI
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 40 C
• Number Of Programmable I/os: 40
• Number Of Timers: 8
• Program Memory Type: Flash
• Supply Voltage - Max: 5.5 V
• Supply Voltage - Min: 3.13 V

192 KByte Flash Module (S12FTMRG192K2V1)
Upon clearing CCIF to launch the Erase Flash Block command, the Memory Controller will erase the
selected Flash block and verify that it is erased. The CCIF flag will set after the Erase Flash Block
operation has completed.
30.4.6.9
The Erase P-Flash Sector operation will erase all addresses in a P-Flash sector.
Upon clearing CCIF to launch the Erase P-Flash Sector command, the Memory Controller will erase the
selected Flash sector and then verify that it is erased. The CCIF flag will be set after the Erase P-Flash
Sector operation has completed.
1126
Register
FSTAT
Erase P-Flash Sector Command
CCOBIX[2:0]
Table 30-48. Erase P-Flash Sector Command FCCOB Requirements
CCOBIX[2:0]
Table 30-46. Erase Flash Block Command FCCOB Requirements
MGSTAT1
MGSTAT0
ACCERR
Error Bit
000
001
FPVIOL
Table 30-47. Erase Flash Block Command Error Handling
000
001
MC9S12G Family Reference Manual,
Global address [15:0] anywhere within the sector to be erased.
Set if CCOBIX[2:0] != 001 at command launch
Set if command not available in current mode (see
Set if an invalid global address [17:16] is supplied
Set if the supplied P-Flash address is not phrase-aligned or if the EEPROM
address is not word-aligned
Set if an area of the selected Flash block is protected
Set if any errors have been encountered during the verify operation
Set if any non-correctable errors have been encountered during the verify
operation
Refer to
Global address [15:0] in Flash block to be erased
0x0A
0x09
Section 30.1.2.1
FCCOB Parameters
FCCOB Parameters
Global address [17:16] to identify
for the P-Flash sector size.
Error Condition
P-Flash block to be erased
Global address [17:16] to
identify Flash block
Rev.1.23
Table
30-27)
Freescale Semiconductor