UPD78F9234MC-5A4-A Renesas Electronics America, UPD78F9234MC-5A4-A Datasheet - Page 182

• Manufacturer Part Number: UPD78F9234MC-5A4-A
• Description: MCU 8BIT 8KB FLASH 30PIN
• Manufacturer: Renesas Electronics America
• Series: 78K0S/Kx1+r

Specifications of UPD78F9234MC-5A4-A

• Core Processor: 78K0S
• Core Size: 8-Bit
• Speed: 10MHz
• Connectivity: LIN, UART/USART
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 24
• Program Memory Size: 8KB (8K x 8)
• Program Memory Type: FLASH
• Ram Size: 256 x 8
• Voltage - Supply (vcc/vdd): 2 V ~ 5.5 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

(5) ANI0/P20 to ANI3/P23
(6) Input impedance of ANI0 to ANI3 pins
(7) Interrupt request flag (ADIF)
180
<1> The analog input pins (ANI0 to ANI3) are also used as I/O port pins (P20 to P23).
<2> If a digital pulse is applied to the pins adjacent to the pins currently used for A/D conversion, the expected
In this A/D converter, the internal sampling capacitor is charged and sampling is performed during sampling time.
Since only the leakage current flows other than during sampling and the current for charging the capacitor also
flows during sampling, the input impedance fluctuates both during sampling and otherwise.
If the shortest conversion time of the reference voltage is used, to perform sufficient sampling, it is recommended
to make the output impedance of the analog input source 1 k
to 0.1 F to the ANI0 to ANI3 pins (see Figure 10-19).
The interrupt request flag (ADIF) is not cleared even if the analog input channel specification register (ADS) is
changed.
Therefore, if an analog input pin is changed during A/D conversion, the A/D conversion result and ADIF for the
pre-change analog input may be set just before the ADS rewrite. Caution is therefore required since, at this time,
when ADIF is read immediately after the ADS rewrite, ADIF is set despite the fact A/D conversion for the post-
change analog input has not ended.
When A/D conversion is stopped and then resumed, clear ADIF before the A/D conversion operation is resumed.
Remarks 1. n = 0 to 3
A/D conversion
When A/D conversion is performed with any of ANI0 to ANI3 selected, do not access port 2 (P20 to P23)
while conversion is in progress; otherwise the conversion resolution may be degraded.
value of the A/D conversion may not be obtained due to coupling noise. Therefore, do not apply a pulse to
the pins adjacent to the pin undergoing A/D conversion.
ADCRH
ADCR,
ADIF
2. m = 0 to 3
ADS rewrite
(start of ANIn conversion)
Figure 10-20. Timing of A/D Conversion End Interrupt Request Generation
ANIn
CHAPTER 10 A/D CONVERTER
ADS rewrite
(start of ANIm conversion)
User’s Manual U17446EJ5V0UD
ANIn
ANIn
or lower, or attach a capacitor of around 0.01 F
ANIm
ANIn
ADIF is set but ANIm conversion
has not ended.
ANIm
ANIm
ANIm