MCIMX286CVM4B Freescale Semiconductor, MCIMX286CVM4B Datasheet - Page 11

• Manufacturer Part Number: MCIMX286CVM4B
• Description: IC MPU I.MX286 289MAPBGA
• Manufacturer: Freescale Semiconductor
• Series: i.MX28r

Specifications of MCIMX286CVM4B

• Core Processor: ARM9
• Core Size: 32-Bit
• Speed: 454MHz
• Connectivity: CAN, EBI/EMI, Ethernet, I²C, MMC, SmartCard, SPI, SSI, UART/USART, USB OTG
• Peripherals: DMA, I²S, LCD, POR, PWM, WDT
• Program Memory Size: 128KB (32K x 32)
• Program Memory Type: Mask ROM
• Ram Size: 32K x 32
• Voltage - Supply (vcc/vdd): 1.25 V ~ 5.25 V
• Data Converters: A/D 17x12b
• Oscillator Type: External
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 289-LFBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Number Of I /o: -
• Eeprom Size: -
• Lead Free Status / Rohs Status: Compliant

3
This section provides the device-level and module-level electrical characteristics for the i.MX28.
3.1
This section provides the device-level electrical characteristics for the IC.
3.1.1
Table 7
Freescale Semiconductor
Battery Pin
5-Volt Source Pin
PSWITCH
Analog Supply Voltage
Digital Core Supply Voltage
Non-EMI Digital I/O Supply
Electrical Characteristics
RTC_XTALO
TESTMODE
provides the DC absolute maximum operating conditions.
RTC_XTALI
RESETN
1
DEBUG
i.MX28
XTALO
Signal
XTALI
DC Absolute Maximum Ratings
•
•
•
Stresses beyond those listed under
damage to the device.
Exposure to absolute-maximum-rated conditions for extended periods
may affect device reliability.
Table 6
not implied beyond the conditions indicated in
Device-Level Conditions
i.MX28 Applications Processor Data Sheet for Consumer Products, Rev. 0
Parameter
These analog pins are connected to an external 24 MHz crystal circuits. This crystal provides
the clock source for on-chip PLLs.
These analog pins are connected to an external 32.768/32.0 kHz crystal circuit. This crystal
provides clock source to the on-chip real-time counter circuits.
This pin resets the chip if it is low. This pin is pulled up to VDDIO33 with an internal resistor. No
external pull up resistors are needed.
This pin is used for JTAG interface.
DEBUG=0: JTAG interface works for boundary scan.
DEBUG=1: JTAG interface works for ARM debugging.
For Freescale factory use only. Must be externally connected to GND for normal operation.
gives stress ratings only—functional operation of the device is
Table 5. Signal Considerations (continued)
Table 6. DC Absolute Maximum Ratings
CAUTION
Table 7
BATT, V
Descriptions
Symbol
may cause permanent
V
V
V
V
DD5V
DDIO
DDD
—
DDA
DD4P2V
Table
8.
Min.
–0.3
–0.3
–0.3
–0.3
–0.3
–0.3
BATT/2
4.242
1.575
Max.
5.25
2.10
3.63
Units
V
V
V
V
V
V
11