AT90USB647-MU Atmel, AT90USB647-MU Datasheet - Page 258

• Manufacturer Part Number: AT90USB647-MU
• Description: MCU, 8BIT, 64K FLASH, USB, 64QFN
• Manufacturer: Atmel

Specifications of AT90USB647-MU

• Controller Family/series: AT90
• No. Of I/o's: 48
• Eeprom Memory Size: 2KB
• Ram Memory Size: 4KB
• Cpu Speed: 16MHz
• No. Of: RoHS Compliant
• Core Size: 8bit
• Program Memory Size: 64KB
• Oscillator Type: External, Internal
• Package: 64QFN EP
• Device Core: AVR
• Family Name: AT90
• Maximum Speed: 20 MHz
• Ram Size: 4 KB
• Operating Supply Voltage: 3.3|5 V
• Data Bus Width: 8 Bit
• Program Memory Type: Flash
• Number Of Programmable I/os: 48
• Interface Type: SPI/TWI/USART/USB
• On-chip Adc: 8-chx10-bit
• Operating Temperature: -40 to 85 °C
• Number Of Timers: 4
• Lead Free Status / Rohs Status: Details

21.8
258
PAD suspend
AT90USB64/128
Note that:
The next figures illustrates the pad behaviour:
Figure 21-15. Pad behaviour
The SUSPI flag indicated that a suspend state has been detected on the USB bus. This flag
automatically put the USB pad in Idle. The detection of a non-idle event sets the WAKEUPI flag
and wakes-up the USB pad.
Moreover, the pad can also be put in the “idle” mode if the DETACH bit is set. It come back in
the active mode when the DETACH bit is cleared.
• the data of Pipe/Endpoint 0 are never lost whatever the activation or deactivation of the
• Deactivate and reactivate the same Pipe/Endpoint with the same parameters does not lead
• CFGOK is set by hardware even in the case where there is a “conflict” in the memory
• In the “idle” mode, the pad is put in low power consumption mode.
• In the “active” mode, the pad is working.
both Pipe/Endpoint 4 and 5 use a common area. The data of those endpoints are potentially
lost.
higher Pipe/Endpoint. Its data is lost if it is deactivated.
to a “slide” of the higher endpoints. For those endpoints, the data are preserved.
allocation.
SUSPI
WAKEUPI
PAD status
Active
Suspend detected = USB pad power down
Idle mode
Resume = USB pad wake-up
| DETACH=1
| suspend
USBE=0
Power Down
& DETACH=0
& suspend
USBE=1
Clear Suspend by software
Clear Resume by software
Active mode
Active
7593K–AVR–11/09