TOOTHPIC RF Solutions, TOOTHPIC Datasheet - Page 26

• Manufacturer Part Number: TOOTHPIC
• Description: MODULE, BLUETOOTH, DATA ACQUISITION
• Manufacturer: RF Solutions

Specifications of TOOTHPIC

• Svhc: No SVHC (15-Dec-2010)

BlueMatik Diagnostic Firmware Solution
This section assumes you have followed the Hello World Firmware Solution tutorials.
Description
The BlueMatik Diagnostic firmware solution is what we use to re-test the low-level ToothPIC Services
communication with the BlueMatik radio module. The source code also provides good examples of how to
use these low-level ToothPIC Services.
BlueMatik Diagnostic runs tests by communicating with its partner application, BlueMatikTestWin.exe,
which must be run on a Windows computer. The source code for the BlueMatikTestWin.exe is included
in the development kit but is not discussed in great detail here. For more in-depth source code for remote
devices connecting to FlexiPanel Ltd’s Bluetooth products, consult the documentation for our BlueMatik
and/or LinkMatik products.
BlueMatik Diagnostic checks master and slave connections, security, device enquiry, bulk data transfer, link
quality and signal strength. Please note that failure to complete these diagnostic tests does not necessarily
mean that ToothPIC is not functioning correctly; the fault may lie elsewhere. In particular, take care to verify
the COM ports and security settings of the Bluetooth driver on the Windows PC.
Executing the Finished Application
BlueMatik Diagnostic is supplied as a Service Pack
application which must be ‘Field Programmed’ into
ToothPIC. This takes a few seconds and requires either
a Windows PC or a Pocket PC with Bluetooth.
procedure is as follows:
Once loaded, the application will start executing
immediately. To experiment with the application, follow
these steps:
Page 26
1. Select either the BlueMatikTestSPWin.exe
2. Power-up the ToothPIC with the on-board
3. Start running the Service Pack and connect from
4. Enter the COM port used to connect to the
5. Press the Update button. Programming takes
6. Start running BlueMatikTestPC.exe on the Windows PC and enter the outgoing and incoming
7. When prompted, and not before, make a serial Bluetooth connection from the Windows PC to
(Windows)
(Pocket PC) service pack from the development
kit. If necessary, transfer the file to the computer
which you’ll use for Field Programming.
pushbutton held down. After initialization, the
on-board LEDs will flash simultaneously.
the computer to the ToothPIC using Bluetooth,
using the PIN code 0000 if required.
ToothPIC in the box provided.
about 10 seconds. When the progress bar is full,
field programming is complete.
COM port numbers as prompted.
ToothPIC.
9-Apr-06
Toothpick 3.0.00007
or
BlueMatikTestSPPPC.exe
DS380-8
© FlexiPanel Ltd
The
Patents apply and/or pending
www.FlexiPanel.com