TOOTHPIC RF Solutions, TOOTHPIC Datasheet - Page 68

• Manufacturer Part Number: TOOTHPIC
• Description: MODULE, BLUETOOTH, DATA ACQUISITION
• Manufacturer: RF Solutions

Specifications of TOOTHPIC

• Svhc: No SVHC (15-Dec-2010)

This memory is free for you to use, other than as follows:
If your user interface uses a large quantity of EE or RAM memory, you must also take care that you do not
overwrite the message queue or the configuration settings. FlexiPanel Designer down not know these are
already allocated and it will not warn you about this.
You can inspect values outside the address limits specified. However, writing to these addresses may cause
the ToothPIC to malfunction.
Breakpoint Command
The command byte 0x10 instructs the ToothPIC to flash its LEDs, allowing the host to indicate that an error
has occurred. It there is no response and no further commands should be sent without resetting the ToothPIC.
The byte after the command byte is a FlashVal value. This value is used to control how the LEDs flash. The
number is flashed as follows:
or
Page 68
Type
EXT4 external memory
(I2C addr 0xB8/0xB9)
EXT5 external memory
(I2C addr 0xBA/0xBB)
EXT6 external memory
(I2C addr 0xBC/0xBD)
EXT7 external memory
(I2C addr 0xBE/0xBF)
Upper ROM block
(0x01xxxx)
-
-
-
-
• Designer.exe requires memory for the user interface as specified at the beginning of the
• RAM locations from 0x8FF downwards are used by the message queue, 0x16 bytes per message.
• EE locations 0x3E0 to 0x3FF are used to store configuration settings.
As many green and red simultaneous flashes as the hundreds digit of FlashVal
As many red flashes as the tens digit of FlashVal
As many green flashes as the units digit of FlashVal
Three green and red simultaneous flashes if FlashVal is zero
computer-generated file it creates.
For example, by default, 0x20 messages can be queued, so 0x640 to 0x8FF are used for the
message queue.
9-Apr-06
Breakpoint Command Examples
Flash 201 (binary)
Toothpick 3.0.00007
value
0x14
0x15
0x16
0x17
0x81
mStr
DS380-8
address
0x0000
0x0000
0x0000
0x0000
0x0000
0x03 0x10 0xC9
Lower
limit
© FlexiPanel Ltd
address
0xDFFF
IC limit
IC limit
IC limit
IC limit
Upper
limit
Patents apply and/or pending
Also used by
User interface (from 0x0000 up).
User interface (from 0x0000 up).
User interface (from 0x0000 up).
User interface (from 0x0000 up).
User interface (from 0x0000 up).
www.FlexiPanel.com