TOOTHPIC RF Solutions, TOOTHPIC Datasheet - Page 29

• Manufacturer Part Number: TOOTHPIC
• Description: MODULE, BLUETOOTH, DATA ACQUISITION
• Manufacturer: RF Solutions

Specifications of TOOTHPIC

• Svhc: No SVHC (15-Dec-2010)

Page 29
10. Select Analog to Digital from the Choose Test list
11. Make sure the I/O pins are unconnected.
12. Select Test Digital Inputs from the Choose Test list
13. Make sure the I/O pins are unconnected.
14. Select Test Parallel Inputs from the Choose Test list
15. Select LED + Pushbutton Test from the Choose Test
16. Select Memory test from the Choose Test list and
17. Select Slider & Progress Bar from the Choose Test
the day-of-week calculation will be updated. You can also change the Daylight Savings Time rules
and, if the appropriate time is set, watch the date and time advance or retard. (See the Real Time
Clock section of the ToothPIC Services Reference
for exact details of when the clock changes.) The
Refresh SecFrac button and the modifiable number
control below it allow you to read and write the
1/32768
have finished this test and each of the following tests.
and press Run Test. Select which input to measure
and see the result in the voltage display. If the pins
are unconnected, you will be measuring stray
voltages which are liable to fluctuate.
select Test Digital Outputs from the Choose Test list
and press Run Test. Press the latching buttons to
set the outputs high or low and use a multimeter to
check the voltages. (SDA and SDO will not work
because these pins are configured for I2C.)
and press Run Test.
indicates the input is ‘high’ and gray indicates the
input is ‘low’. If the pins are unconnected, you will
be measuring stray voltages which will fluctuate.
select Test Parallel Outputs from the Choose Test
list and press Run Test. These are the same as the
regular digital outputs except the values change
simultaneously.
parallel data or if you need to tie several outputs
together to drive loads greater than 25mA.
and press Run Test. These are the same as the
regular digital
measured simultaneously.
list and press Run Test. You can control the LEDs
and make various message boxes appear by
pressing the ToothPIC pushbutton.
press Run Test. Read and write to memory. Note
that if no external memory is connected, you will get
a memory failure error if you try and read or write to
it. Also, don’t write to a memory location unless you
are sure that ToothPIC isn’t using it!
list and press Run Test. When you move the slider,
the progress bar moves.
available on all clients and you may find that all you
see are a modifiable and a non-modifiable number
9-Apr-06
ths
of a second. Press End Test when you
Toothpick 3.0.00007
inputs
This is useful when transmitting
except
A red background color
These controls are not
DS380-8
the values are
© FlexiPanel Ltd
Then
Then
Patents apply and/or pending
www.FlexiPanel.com