TOOTHPIC RF Solutions, TOOTHPIC Datasheet - Page 86

• Manufacturer Part Number: TOOTHPIC
• Description: MODULE, BLUETOOTH, DATA ACQUISITION
• Manufacturer: RF Solutions

Specifications of TOOTHPIC

• Svhc: No SVHC (15-Dec-2010)

For forward compatibility, ignore any undocumented BMTE_ events rather than generating an error. This
allows us to add new events in future without upsetting existing firmware.
BMTE_Disco: The BlueMatik transmit buffer is reset if a disconnect message is received.
BMTE_Modem: If the remote device sends a modem status message, a BMTE_Modem event is generated.
The value of *pData1 is a bitwise-OR combination of the following:
The value of *pData2 is a bitwise-OR combination of the following:
Note that the extent to which remote devices support modem status messages may vary. The break signal is
optional.
BMTE_HostProgram: Reserved for FlexiPanel Ltd use.
BMTE_General: Any other response from BlueMatik, usually as a result of a BMTC_General command.
BMTE_Warning and BMTE_Error do not trigger the ErrorStatus callback. However, a BMTE_OK event is
issued after the BMTE_Warning and BMTE_Error event and also the ProcessingATCommand is cleared
so that AwaitBMTOK does not block. This way execution can continue if possible.
The error and warning error codes are described in detail the BlueMatik documentation, but briefly, the most
likely are:
Page 86
Bitwise-OR value
0x01
0x02
0x04
0x08
0x10
Bitwise-OR value
0x40
0x0F
9-Apr-06
(hex)
(hex)
0F
10
11
12
15
17
18
19
1C
80
81
82
83
84
85
86
Warning code
Error code
Toothpick 3.0.00007
(decimal)
(decimal)
128
129
130
131
132
133
134
15
16
17
18
21
23
24
25
28
Meaning
RTC (Ready to communicate)
RTR (Ready to receive)
IC (Incoming call)
DV (Data valid)
FC (Flow control)
Meaning
Remaining *pData2 fields are valid
Length of break signal in units of 200ms
General error – see note below
Connection attempt while module not idle
Operation can’t be performed while active connection exists
Inquiry attempt while module not idle
Command unexpected or out of context
Command requires active serial connection
Operation cannot be cancelled – see note below
BlueMatik Link Database Error
Flash memory too fragmented – perform BlueMatik reset
Sniff mode not enabled on BlueMatik
Hold mode not enabled on BlueMatik
No low power modes enabled on BlueMatik
Remote device does not support sniff mode
Remote device does not support hold mode
No low power modes supported on remote device
Low power mode has not changed
DS380-8
© FlexiPanel Ltd
Warning description
Error description
Patents apply and/or pending
www.FlexiPanel.com