TOOTHPIC RF Solutions, TOOTHPIC Datasheet - Page 51

• Manufacturer Part Number: TOOTHPIC
• Description: MODULE, BLUETOOTH, DATA ACQUISITION
• Manufacturer: RF Solutions

Specifications of TOOTHPIC

• Svhc: No SVHC (15-Dec-2010)

That completes the quick tour. For more information on commands, etc, refer to the section Guide to
Page 51
15. When you successfully connect, you will see a very simple User
16. This user interface is a bit dull, so we will now
17. Power-up the ToothPIC Slave with the pushbutton pressed down.
18. When programming is complete, ToothPIC Slave will
Interface as shown in the graphic on the right. It contains only the
words ‘ToothPIC Slave’.
following responses:
The 09050308 message is from BlueMatik and indicates that a Bluetooth device has connected. The
last 12 characters are the Bluetooth ID of the device. The 030601 message is from the FlexiPanel
server and indicates that the device is a FlexiPanel Client.
program a more interesting User Interface into
ToothPIC Slave. Run the FlexiPanel Designer
application
SlaveTestRes.FxP from the development kit.
This
DARCIITestRes.FxP example used in the
DARC-II firmware solution, except that the target
has been set to ToothPIC Slave. If you want to
know more about what all the settings mean and
how the file was created, follow the tutorial in the
DARC-II module product documentation.
The LEDs will flash rapidly, indicating that it is allowing itself to
be configured. Connect to the module from your Windows PC
and make a note of the COM port that Bluetooth uses.
FlexiPanel Designer menu, select View > ToothPIC Slave
Properties and, in the properties list on the right, find the property
‘Programming COM Port’ and set the value to the COM port that
Bluetooth is using. In FlexiPanel Designer menu, select Target
Device > Program ToothPIC Slave from the menu. The user
interface will be programmed into the ToothPIC Slave.
automatically reset and you will see the initialization
message again in the HyperTerminal window. Set the
application name and restart the FlexiPanel Service
again by typing into HyperTerminal the following:
and then connect to ToothPIC again from a FlexiPanel
client. The User Interface will be the same as the
DARC-II module. If you modify any controls, you will
get corresponding responses in the HyperTerminal
window. Type the following into HyperTerminal:
Observe how you just added rows to the matrix control.
9-Apr-06
is
090503080046B939B0
030601
030601
060D00050000
060D0005FF03
060D0005FF01
Toothpick 3.0.00007
exactly
and
the
open
In HyperTerminal, you should see the
same
DS380-8
the
as
© FlexiPanel Ltd
(Last 12 chars will differ.)
the
file
Patents apply and/or pending
In
www.FlexiPanel.com