KMA199,115 NXP Semiconductors, KMA199,115 Datasheet - Page 23

• Manufacturer Part Number: KMA199,115
• Description: IC SENSOR PROG ANGLE SOT880
• Manufacturer: NXP Semiconductors

Specifications of KMA199,115

• Operational Type: Programmable Angle Sensor
• Operating Supply Voltage: 5 V
• Supply Current: 5 mA to 10 mA
• Package / Case: SOT-880
• Mounting Style: Through Hole
• Supply Voltage (min): 4.5 V
• Supply Voltage (max): 5.5 V
• Maximum Output Current: 20 mA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

NXP Semiconductors
Table 16.
KMA199_1
Product data sheet
Command
write/read
82h/83h
94h/-
96h/97h
Command registers
Register
CTRL1
SIGNATURE 15 to 0
TESTCTRL0 15 to 12
13.5.1 Command registers
13.5 Registers
To enter the command mode, the signature given in
OWI into the specific register. This must be done as described in
write command, followed by the signature, but after a power-on reset and not later than
t
cmd(ent)
Bit
15
14
13
12
11
10 and 9 -
8
7
6
5
4
3 to 0
11
10 to 0
.
Access Field
R
R/W
-
R
R/W
R
R
R
-
R
-
W
-
W
-
All information provided in this document is subject to legal disclaimers.
IN_DIAG_MODE
FORCE_DIAG_OFF
-
LOW_VOLTAGE_DET low voltage condition detected
EEP_CP_CLOCK_EN charge pump clock on (must be set after setting
-
EEP_ERR_CORRECT EDC: EEPROM error has been corrected; updated
EEP_UNCORR_ERR
MAGNET_LOSS_DET magnet-loss detected; bit remains set even if the
-
CRC_BAD
-
SIGNATURE
-
EEP_WRITE_EN
-
Rev. 01 — 26 April 2010
Description
shows if there is a diagnostic condition present;
this bit is not affected by the setting of the register
field FORCE_DIAG_OFF
force diagnostic mode off; default: 0b
reserved
EEPROM write enable signal for writing to
EEPROM); default: 0b
reserved
every EEPROM readout and remains set once set
EDC: EEPROM uncorrectable error has been
detected; updated every EEPROM readout and
remains set once set
condition disappears; for this detection which leads
to diagnostic mode, the magnet-loss detection
must be enabled
reserved
CRC check has failed (checked during start-up)
reserved
write signature 9BA4h within t
command mode; see
details
reserved
EEPROM write enable signal (must be set before
writing to EEPROM)
0605h — disabled (default)
0E05h — enabled
reserved
Table 16
Programmable angle sensor
must be written using the
Section 13.3.3
Section
cmd(ent)
© NXP B.V. 2010. All rights reserved.
KMA199
13.3.3, with a
for more
to enter
23 of 36