KMA199,115 NXP Semiconductors, KMA199,115 Datasheet - Page 4

IC SENSOR PROG ANGLE SOT880

KMA199,115

Manufacturer Part Number
KMA199,115
Description
IC SENSOR PROG ANGLE SOT880
Manufacturer
NXP Semiconductors
Datasheet

Specifications of KMA199,115

Operational Type
Programmable Angle Sensor
Operating Supply Voltage
5 V
Supply Current
5 mA to 10 mA
Package / Case
SOT-880
Mounting Style
Through Hole
Supply Voltage (min)
4.5 V
Supply Voltage (max)
5.5 V
Maximum Output Current
20 mA
Lead Free Status / RoHS Status
Lead free / RoHS Compliant

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
KMA199,115
Manufacturer:
NXP/恩智浦
Quantity:
20 000
NXP Semiconductors
5. Functional description
KMA199_1
Product data sheet
5.1 Angular measurement directions
The KMA199 amplifies two orthogonal differential signals which are delivered by MR
sensor bridges and converts them into the digital domain. The angle is calculated using
the COordinate Rotation DIgital Computer (CORDIC) algorithm. After a digital-to-analog
conversion the analog signal is provided to the output. Thus, the output is a linear
representation of the angular value. Zero angle, clamping voltages and angular range are
programmable. In addition, two 16-bit registers are available for customer purposes, like
sample identification.
The KMA199 comprises a Cyclic Redundancy Check (CRC) and an Error Detection and
Correction (EDC) supervision, as well as a magnet-loss detection to ensure a fail-safe
operation. A power-loss detection circuit pulls the analog output to the remaining supply
line, if either the supply voltage or the ground line is interrupted.
After multiplexing the two MR Wheatstone bridge signals and their successive
amplification, the signal is converted into the digital domain by an Analog-to-Digital
Converter (ADC). Further processing is done within an on-chip state machine. This
includes offset cancellation, calculation of the mechanical angle using the CORDIC
algorithm, as well as zero angle and angular range adjustment. The internal
Digital-to-Analog Converter (DAC) and the analog output stage are used for conversion of
the angle information into an analog output voltage, which is ratiometric to the supply
voltage.
The configuration parameters are stored in an user-programmable EEPROM. The OWI
(accessible using pin OUT/DATA) is used for accessing the memory.
The differential signals of the MR sensor bridges depend only on the direction of the
external magnetic field strength H
In order to obtain a correct output signal, the minimum saturation field strength has to be
exceeded.
All information provided in this document is subject to legal disclaimers.
Rev. 01 — 26 April 2010
ext
, which is applied parallel to the plane of the sensor.
Programmable angle sensor
© NXP B.V. 2010. All rights reserved.
KMA199
4 of 36

Related parts for KMA199,115