SI3200-G-GS Silicon Laboratories Inc, SI3200-G-GS Datasheet - Page 74

• Manufacturer Part Number: SI3200-G-GS
• Description: SLIC 2-CH 63dB 45mA 3.3V 6-Pin SMD
• Manufacturer: Silicon Laboratories Inc
• Series: ProSLIC®r

Specifications of SI3200-G-GS

• Package: 6SMD
• Number Of Channels Per Chip: 2
• Polarity Reversal: Yes
• Longitudinal Balanced: 63 dB
• Loop Current: 45 mA
• Minimum Operating Supply Voltage: 3.13 V
• Typical Operating Supply Voltage: 3.3 V
• Typical Supply Current: 0.11 mA
• Function: Subscriber Line Interface Concept (SLIC), CODEC
• Interface: GCI, PCM, SPI
• Number Of Circuits: 2
• Voltage - Supply: 3.3V, 5V
• Current - Supply: 110µA
• Power (watts): 941mW
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 16-SOIC (3.9mm Width)
• Includes: Battery Switching, BORSCHT Functions, DTMF Generation and Decoding, FSK Tone Generation, Modem and Fax Tone Detection
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Si3220/25 Si3200/02
The control byte has the following structure and is presented on the SDI pin MSB first:
See Table 42 for bit definitions.
74
3:0
7
6
5
4
REG/RAM Register/RAM Access Bit.
Reserved
BRDCST Indicates a broadcast operation that is intended for all devices in the daisy chain. This is
CID[3:0]
R/W
BRDCST R/W REG/RAM Reserved CID[0] CID[1] CID[2] CID[3]
only valid for write operations since it would cause contention on the SDO pin during a
read.
Read/Write Bit.
0 = Write operation.
1 = Read operation.
0 = RAM access.
1 = Register access.
Indicates the channel that is targeted by the operation. Note that the 4-bit channel value is
provided LSB first. The devices reside on the daisy chain such that device 0 is nearest to
the controller, and device 15 is furthest down the SDI/SDU_THRU chain. (See Figure 41.)
As the CID information propagates down the daisy chain, each channel decrements the
CID by 1. The SDI nodes between devices reflect a decrement of 2 per device since each
device contains two channels. The device receiving a value of 0 in the CID field responds
to the SPI transaction. (See Figure 42.) If a broadcast to all devices connected to the chain
is requested, the CID does not decrement. In this case, the same 8-bit or 16-bit data is pre-
sented to all channels regardless of the CID values.
7
6
Table 42. SPI Control Interface
5
Rev. 1.3
4
3
2
1
0