PSB50505EV13GXT Lantiq, PSB50505EV13GXT Datasheet - Page 113

• Manufacturer Part Number: PSB50505EV13GXT
• Manufacturer: Lantiq

Specifications of PSB50505EV13GXT

• Lead Free Status / RoHS Status: Supplier Unconfirmed

5.5.2
The IWE8 microprocessor interface allows connection of Intel type microprocessors as
well as Motorola type microprocessors (e.g. the PowerPC).
The Microprocessor Interface Mode is determined via the status of the pins PMT and
TBUS at the positive edge of the internal reset. Therefore, PMT and TBUS levels have
to be kept at least 3 clock cycles after deassertion of RESET.
Table 28 Configuration of the Microprocessor Interface Mode
PMT
0
1
The mode currently assigned to the microprocessor interface is visible via “mtypsel” in
the “Version Register” (“vers”, see
Intel Mode
The connection of the 16 bit Intel compatible asynchronous microprocessor interface to
an Intel 386EX processor is shown in
If the ready signal at pin MPRDY shall be used, a glue logic between MPRDY of the
IWE8 and RDY of the 386EX is required, which generates an active low signal with 1
microprocessor cycle length after a rising edge detection of the MPRDY signal.
Figure 32
Motorola Mode
Figure 33
interface to the MC68xxx.
Data Sheet
shows the connection of the 16 bit Motorola compatible asynchronous
Microprocessor Interface Mode
Connection of IWE8 to an Intel Type Microprocessor
Intel i386 EX
TBUS
0
1
DATA[0-15]
ADR[1-18]
CSn
INTi
INTj
WR
RD
Chapter
Figure
113
Mode
Intel Mode
Motorola Mode
7.16).
PXB 4219E, PXB 4220E, PXB 4221E
32.
MPIR2
MPIR1
MPCS
MPRD
MPWR
MPDAT[0-15]
MPADR[0-17]
IWE8
Interface Description
IWE8, V3.4
2003-01-20
Coitm