PEB4265VV12NT Infineon Technologies, PEB4265VV12NT Datasheet - Page 193

• Manufacturer Part Number: PEB4265VV12NT
• Manufacturer: Infineon Technologies

Specifications of PEB4265VV12NT

• On-hook Transmission: Yes
• Polarity Reversal: Yes
• On-chip Ring Relay Driver: Yes
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Pin Count: 22
• Mounting: Surface Mount
• Lead Free Status / RoHS Status: Not Compliant

Preliminary
AC-XGAIN Analog gain in transmit direction (should be set to zero).
UTDX-SRC
PDOT-DIS
Data Sheet
AC-XGAIN = 0
AC-XGAIN = 1
Power Down Overtemperature Disable
PDOT-DIS = 0
PDOT-DIS = 1
Universal Tone Detector transmit source
UTDX-SRC = 0
UTDX-SRC = 1
(see
Figure 32
No additional analog gain in transmit direction.
Additional 6 dB analog amplification in transmit
direction.
on
SLICOFI-2x Command Structure and Programming
When overtemperature is detected, the SLIC is
automatically switched into Power Down High
Impedance mode (PDH). This is the safe operation
mode for the SLIC-E/-E2/-P in case of
overtemperature. To leave the automatically
activated PDH mode, DuSLIC has to be switched
manually to PDH mode and then in the mode as
desired.
When over temperature is detected, the SLIC-E/-E2/
-P doesn’t automatically switch into Power Down
High Impedance mode. In this case the output
current of the SLIC-E/-E2/-P buffers is limited to a
value which keeps the SLIC-E/-E2/-P temperature
below the upper temperature limit.
from the transmit path directly (UTDX-SUM = 0) or
uses the data from the sum signal of receive path
and LEC (if LEC is enabled) (UTDX-SUM = 1).
from the LEC output, if the LEC is enabled (LEC-EN
= 1), otherwise the UTD unit uses automatically the
transmit signal.
The Universal Tone Detection unit uses the data
The Universal Tone Detection unit uses the data
Page
63)
193
DuSLIC-E/-E2/-P
2000-07-14