EP2AGX190FF35C6N Altera, EP2AGX190FF35C6N Datasheet - Page 586

• Manufacturer Part Number: EP2AGX190FF35C6N
• Description: IC ARRIA II GX 190K 1152FBGA
• Manufacturer: Altera
• Series: Arria II GXr

Specifications of EP2AGX190FF35C6N

• Number Of Logic Elements/cells: 181165
• Number Of Labs/clbs: 7612
• Total Ram Bits: 9939
• Number Of I /o: 612
• Voltage - Supply: 0.87 V ~ 0.93 V
• Mounting Type: Surface Mount
• Operating Temperature: 0°C ~ 85°C
• Package / Case: 1152-FBGA
• Family Name: Arria® II GX
• Number Of Logic Blocks/elements: 190300
• # I/os (max): 612
• Frequency (max): 400MHz
• Operating Supply Voltage (typ): 900mV
• Logic Cells: 190300
• Ram Bits: 10380902.4
• Operating Supply Voltage (min): 0.87V
• Operating Supply Voltage (max): 0.93V
• Operating Temp Range: 0C to 85C
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 1152
• Package Type: FC-FBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Number Of Gates: -
• Lead Free Status / Rohs Status: Compliant

4–12
Figure 4–7. Sample Reset Sequence of Receiver-Only Channel—Receiver CDR in Manual Lock Mode
Arria II Device Handbook Volume 2: Transceivers
Reset Signals
CDR Control Signals
Output Status Signals
rx_analogreset
rx_locktorefclk
rx_digitalreset
rx_locktodata
rx_pll_locked
Receiver Only Channel—Receiver CDR in Manual Lock Mode
This configuration contains only a receiver channel. If you create a Receiver Only
instance in the ALTGX MegaWizard Plug-In Manager with the receiver CDR in
manual lock mode, use the reset sequence shown in
As shown in
CDR in manual lock mode:
1. After power up, assert rx_analogreset for a minimum period of two parallel
2. Keep the rx_digitalreset and rx_locktorefclk signals asserted and the
3. After de-assertion of the busy signal, de-assert the rx_analogreset signal, after
4. Wait at least 15 s (the time between markers 3 and 4) after the rx_pll_locked
5. De-assert rx_digitalreset at least 4 s (the time between markers 4 and 5) after
busy
clock cycles (the time between markers 1 and 2).
rx_locktodata signal de-asserted during this time period.
which the receiver CDR starts locking to the receiver input reference clock because
the rx_locktorefclk signal is asserted.
signal goes high, and then de-assert the rx_locktorefclk signal. At the same time,
assert the rx_locktodata signal (marker 4). At this point, the receiver CDR enters
lock-to-data mode and the receiver PLL starts locking to the received data.
asserting the rx_locktodata signal.
Figure
Two parallel clock cycles
1
4–7, perform the following reset sequence steps for the receiver
2
3
Chapter 4: Reset Control and Power Down in Arria II Devices
15 μs
4
4
4 μs
5
Figure
4–7.
December 2010 Altera Corporation
Transceiver Reset Sequences