ST92T163R4T1 STMicroelectronics, ST92T163R4T1 Datasheet - Page 63

• Manufacturer Part Number: ST92T163R4T1
• Description: Microcontrollers (MCU) OTP EPROM 20K USB/I2
• Manufacturer: STMicroelectronics

Specifications of ST92T163R4T1

• Data Bus Width: 8 bit, 16 bit
• Program Memory Type: EPROM
• Program Memory Size: 20 KB
• Data Ram Size: 2 KB
• Interface Type: I2C, SCI, USB
• Maximum Clock Frequency: 24 MHz
• Number Of Programmable I/os: 64
• Number Of Timers: 2
• Operating Supply Voltage: 4 V to 5.5 V
• Maximum Operating Temperature: + 70 C
• Mounting Style: SMD/SMT
• Package / Case: TQFP-64
• Minimum Operating Temperature: 0 C
• On-chip Adc: 8 bit
• Lead Free Status / Rohs Status: No

3.12 WAKE-UP / INTERRUPT LINES MANAGEMENT UNIT (WUIMU)
3.12.1 Introduction
The Wake-up/Interrupt Management Unit extends
the number of external interrupt lines from 8 to 23
(depending on the number of external interrupt
lines mapped on external pins of the device). It al-
lows the source of the INTD1 external interrupt
channel to be selected between the INT7 pin and
up to 16 additional external Wake-up/interrupt
pins.
These 16 WKUP pins can be programmed as ex-
ternal interrupt lines or as wake-up lines, able to
exit the microcontroller from low power mode
(STOP mode) (see Figure 30).
Figure 30. Wake-Up Lines / Interrupt Management Unit Block Diagram
STOP
Note: Reset Signal
on stop bit is
stronger than
the set signal
WKUP[ 7:0]
SW SETT ING
WUCTR L
WUTRL
WUPRL
WUMRL
WKUP[15:8]
3.12.2 Main Features
Note: The number of available pins is device de-
pendent. Refer to the device pinout description.
1
WUMRH
Supports up to 16 additional external wake-up
or interrupt lines
Wake-Up lines can be used to wake-up the ST9
from STOP mode.
Programmable selection of wake-up or interrupt
Programmable wake-up trigger edge polarity
All Wake-Up Lines maskable
WUPRH
WUTRH
TO RCCU - Stop Mode Control
0
TRIGGERING LEVEL REGISTERS
PENDING REQUEST REGISTERS
MASK REGISTERS
INTD1 - External Interrupt Channel
ST92163 - INTERRUPTS
TO CPU
INT7
63/224