SDKZSPF LSI, SDKZSPF Datasheet - Page 194

• Manufacturer Part Number: SDKZSPF
• Manufacturer: LSI

Specifications of SDKZSPF

• Lead Free Status / Rohs Status: Supplier Unconfirmed

Table 9.5
1. This command may also be invoked without the target name. See
9.2.4 JTAG Probe Connection
9-8
Command
close file filename
help
max_number_of_files number
memory_download filename addr size Write size of items to memory addr from file
memory_upload filename addr size
Specific Commands”
UART Target Commands
contains the UART debug code. For instructions on programming the
flash memory, refer to the application note, Programming the Flash. To
ensure that your EB402 Evaluation Board is booted from (external) flash
memory, set the IBOOT pin LOW. Refer also to the EB402 Evaluation
Board User’s Guide.
Use the commands in
though the serial port connection.
The format for serial port commands is:
To use the JTAG connection, you must install a Corelis PCI or PCMCIA
Type II Boundary Scan Controller card in your machine and install a
cable connecting it to your evaluation board.
The JTAG target is invoked by the following commands:
Debugger
Copyright © 1999-2003 by LSI Logic Corporation. All rights reserved.
on page
(sdbug) sdsp-remote sdsp-remote-command
(sdbug) jtag set_clk 2 0 0
(sdbug) target jtag
Note:
9-13
The JTAG target is available only for Windows
98/NT/2000/XP platforms.
for details.
Description
Close file filename.
List UART connection commands.
Specify the maximum number of files that can be
opened at the same time.
filename. addr can be a label.
Read size of items from memory addr to file
filename. addr can be a label.
Table 9.5
to communicate with the target board
1
Section 9.3.1, “Generic Target-
1
1
1