SDKZSPF LSI, SDKZSPF Datasheet - Page 302

• Manufacturer Part Number: SDKZSPF
• Manufacturer: LSI

Specifications of SDKZSPF

• Lead Free Status / Rohs Status: Supplier Unconfirmed

12-42
Figure 12.55
Setting up an Update Point –
An Update point is a marker in a source window. Whenever the
application control flow crosses this point, all the plots related to this
update point are updated. Here is the procedure for setting an Update
point:
ZSP IDE Debugger
Copyright © 1999-2003 by LSI Logic Corporation. All rights reserved.
The Boundary Setting dialog box appears, as shown in
This is where you enter the minimum and maximum values to be
plotted on the X, Y and Z axes: Xmin, Xmax, Ymin, Ymax, Zmin, and
Zmax, respectively.
Additional values must be entered for Altitude and Azimuth (in
degrees) to set the viewing angles. The Altitude represents the
viewing angle above the XY plane.
The Azimuth is defined so that when
plane face-on. As the angle is increased, the plot is rotated counter-
clockwise as viewed from above the XY plane.
When all required information is entered, click on OK. A new DG
window for 3D (top level) is opened with the entered values of Xmin,
Xmax, Ymin, Ymax, Zmin, and Zmax.
At this point, this DG window is ready for 3D plotting.
Left-click on the line number column in the "C" source window in the
Debugger IDE. The Plot Type dialog box appears, as shown in
Figure
variable or a memory range.
12.56). In this dialog box, you can choose to plot a "C"
3D Boundary Setting Dialog Box
it is
0, the observer sees the XZ
Figure
12.55.