AT32UC3C2512C Automotive Atmel Corporation, AT32UC3C2512C Automotive Datasheet - Page 1048
AT32UC3C2512C Automotive
Manufacturer Part Number
AT32UC3C2512C Automotive
Description
Manufacturer
Atmel Corporation
Datasheets
1.AT90CAN128_AUTOMOTIVE.pdf
(225 pages)
2.AT32UC3C0512C_AUTOMOTIVE.pdf
(1312 pages)
3.AT32UC3C0512C_AUTOMOTIVE.pdf
(107 pages)
- AT90CAN128_AUTOMOTIVE PDF datasheet
- AT32UC3C0512C_AUTOMOTIVE PDF datasheet #2
- AT32UC3C0512C_AUTOMOTIVE PDF datasheet #3
- Current page: 1048 of 1312
- Download datasheet (20Mb)
34.5.2
34.5.3
34.5.4
34.5.5
34.5.6
34.6
34.6.1
34.6.1.1
9166C–AVR-08/11
Functional Description
Power Management
Clocks
Interrupts
Peripheral Events
Debug Operation
Basic Operation
Enabling the QDEC
If the CPU enters a sleep mode that disables clocks used by the QDEC, the QDEC will stop
functioning and resume operation after the system wakes up from sleep mode.
The QDEC has two clocks connected: One Peripheral Bus clock (CLK_QDEC) and one generic
clock (GCLK_QDEC). These clocks are generated by the Power Manager. CLK_QDEC is
enabled at reset, and can be disabled in the Power Manager.
GCLK_QDEC is used for filtering in QDEC mode and is the timer clock in Timer Mode. It is a
generic clock generated by the Power Manager. The programmer must configure the Power
Manager to enable GCLK_QDEC. The GCLK_QDEC frequency must less than half the
CLK_QDEC clock frequency.
The QDEC interrupt request line is connected to the interrupt controller. Using the QDEC inter-
rupt requires the interrupt controller to be programmed first.
The QDEC peripheral events are connected via the Peripheral Event System. Refer to the
Peripheral Event System chapter for details.
When an external debugger forces the CPU into debug mode, the QDEC continues normal
operation; the timer is not frozen, but peripheral events are masked.
In OCD mode, the timer is not frozen and the events are masked. Reading the CAP register
does not clear the reminding of last capture event for the OVR interrupt.
If the QDEC is configured in a way that requires it to be periodically serviced by the CPU through
interrupts or similar, improper operation or data loss may result during debugging.
The QDEC peripheral events are masked during debug operation, unless the Run In Debug bit
in the Development Control Register is written to one and the bit corresponding to the QDEC is
written to one in the Peripheral Debug Register (PDBG). Please refer to the On-Chip Debug
chapter in the AVR32UC Technical Reference Manual, and the OCD Module Configuration sec-
tion, for details.
The QDEC is enabled by writing a one to the Clock Enable bit in the Control Register
(CTRL.CLKEN). This will also enable the internal CLK_QDEC_INT. This clock is generated from
GCLK_QDEC.
CLK_QDEC_INT is used in the filter blocks and for clocking the counter in Timer Mode. A soft-
ware trigger or peripheral event trigger is needed for CLK_QDEC_INT to start. The Clock Enable
bit in the Status Register (SR.CLKEN) indicates if the clock is running.
AT32UC3C
1048
Related parts for AT32UC3C2512C Automotive
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Manufacturer:
Atmel Corporation
Datasheet:
Part Number:
Description:
INTERVAL AND WIPE/WASH WIPER CONTROL IC WITH DELAY
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Low-Voltage Voice-Switched IC for Hands-Free Operation
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
MONOLITHIC INTEGRATED FEATUREPHONE CIRCUIT
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
AM-FM Receiver IC U4255BM-M
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Monolithic Integrated Feature Phone Circuit
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Multistandard Video-IF and Quasi Parallel Sound Processing
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
High-performance EE PLD
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
8-bit Flash Microcontroller
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
2-Wire Serial EEPROM
Manufacturer:
ATMEL Corporation
Datasheet: