AD7864 Analog Devices, AD7864 Datasheet - Page 20

• Manufacturer Part Number: AD7864
• Description: High Speed, Low Power, 4-channel Simultaneous Sampling, 12-Bit ADC
• Manufacturer: Analog Devices

Specifications of AD7864

• Resolution (bits): 12bit
• # Chan: 4
• Sample Rate: 520kSPS
• Interface: Par
• Analog Input Type: SE-Bip,SE-Uni
• Ain Range: Bip 10V,Bip 2.5V,Bip 5.0V,Uni 2.5V,Uni 5.0V
• Adc Architecture: SAR
• Pkg Type: QFP

AD7864
OFFSET AND FULL-SCALE ADJUSTMENT
In most digital signal processing (DSP) applications, offset and
full-scale errors have little or no effect on system performance.
Offset error can always be eliminated in the analog domain by
ac coupling. Full-scale error effect is linear and does not cause
problems as long as the input signal is within the full dynamic
range of the ADC. Invariably, some applications require that the
input signal spans the full analog input dynamic range. In such
applications, offset and full-scale error have to be adjusted to zero.
Figure 15 shows a circuit that can be used to adjust the offset
and full-scale errors on the AD7864 (V
version is shown for example purposes only). Where adjustment
is required, offset error must be adjusted before full-scale error.
This is achieved by trimming the offset of the op amp driving
the analog input of the AD7864 while the input voltage is 1/2
LSB below analog ground. The trim procedure is as follows:
apply a voltage of −2.44 mV (−1/2 LSB) at V
adjust the op amp offset voltage until the ADC output code
flickers between 1111 1111 1111 and 0000 0000 0000.
Adjust gain error at either the first code transition (ADC
negative full scale) or the last code transition (ADC positive full
scale). The trim procedures for both cases are as follows.
POSITIVE FULL-SCALE ADJUST
Apply a voltage of 9.9927 V (FS − 3/2 LSB) at V
until the ADC output code flickers between 0111 1111 1110 and
0111 1111 1111.
INxA
on the AD7864-1
1
in Figure 15 and
1
and adjust R2
Rev. D | Page 20 of 28
NEGATIVE FULL-SCALE ADJUST
Apply a voltage of −9.9976 V (−FS + 1/2 LSB) at V
R2 until the ADC output code flickers between 1000 0000 0000
and 1000 0000 0001.
An alternative scheme for adjusting full-scale error in systems
that use an external reference is to adjust the voltage at the V
pin until the full-scale error for any of the channels is adjusted
out. Good full-scale matching of the channels ensures small
full-scale errors on the other channels.
INPUT
RANGE = ±10V
*ADDITIONAL PINS OMITTED FOR CLARITY.
10kΩ
500Ω
10kΩ
R1
R2
R3
V
1
Figure 15. Full-Scale Adjust Circuit
R5
10kΩ
10kΩ
R4
V
AGND
AD7864-1*
INxA
1
and adjust
REF