ST10F273Z4 STMicroelectronics, ST10F273Z4 Datasheet - Page 73

• Manufacturer Part Number: ST10F273Z4
• Description: 16-BIT MICROCONTROLLER WITH MAC UNIT, UP TO 832 KBYTES FLASH MEMORY AND UP TO 68 KBYTES RAM
• Manufacturer: STMicroelectronics

Specifications of ST10F273Z4

• Single Voltage Supply: 5 V ±10%

ST10F273Z4
16
I
The integrated I
two-line SDA/SCL in accordance with the I
operate in slave mode, in master mode or in multi-master mode. It can receive and transmit
data using 7-bit or 10-bit addressing. Data can be transferred at speeds up to 400 Kbit/s
(both Standard and Fast I
The module can generate three different types of interrupt:
●
●
●
These requests are issued to the interrupt controller by three different lines, and identified as
Error, Transmit, and Receive interrupt lines.
When the I
P4.7 (where SCL and SDA are respectively mapped as alternate functions) are
automatically configured as bidirectional open-drain: the value of the external pull-up
resistor depends on the application. P4, DP4 and ODP4 cannot influence the pin
configuration.
When the I
controlled by P4, DP4 and ODP4.
The speed of the I
Fast I
2
C interface
Requests related to bus events, like start or stop events, arbitration lost, etc.
Requests related to data transmission
Requests related to data reception
2
C mode (100 to 400 kHz).
2
2
C module is enabled by setting bit XI2CEN in XPERCON register, pins P4.4 and
C cell is disabled (clearing bit XI2CEN), P4.4 and P4.7 pins are standard I/ O
2
C Bus Module handles the transmission and reception of frames over the
2
C interface may be selected between Standard mode (0 to 100 kHz) and
2
C bus modes are supported).
2
C Bus specification. The I
2
C Module can
I2C interface
73/188