upd78f0114m6gb-8es Renesas Electronics Corporation., upd78f0114m6gb-8es Datasheet - Page 174

• Manufacturer Part Number: upd78f0114m6gb-8es
• Description: 8-bit Single-chip Microcontrollers
• Manufacturer: Renesas Electronics Corporation.

7.4.2 Operation as external event counter
(TM5n).
Either the rising or falling edge can be selected.
and an interrupt request signal (INTTM5n) is generated.
174
The external event counter counts the number of external clock pulses to be input to TI5n by 8-bit timer counter 5n
TM5n is incremented each time the valid edge specified by timer clock selection register 5n (TCL5n) is input.
When the TM5n count value matches the value of 8-bit timer compare register 5n (CR5n), TM5n is cleared to 0
Whenever the TM5n value matches the value of CR5n, INTTM5n is generated.
<1> Set each register.
<2> When TCE5n = 1 is set, the number of pulses input from TI5n is counted.
<3> When the values of TM5n and CR5n match, INTTM5n is generated (TM5n is cleared to 00H).
<4> After these settings, INTTM5n is generated each time the values of TM5n and CR5n match.
Note 8-bit timer/event counter 50: PM17
Setting
TM5n count value
• Set the port mode register (PM17 or PM33)
• TCL5n: Select TI5n input edge.
• CR5n:
• TMC5n: Stop the count operation, select the mode in which clear & start occurs on match of TM5n and
Remark N = 00H to FFH
8-bit timer/event counter 51: PM33
INTTM5n
Figure 7-12. External Event Counter Operation Timing (with Rising Edge Specified)
CR5n
TI5n
n = 0, 1
TI5n falling edge → TCL5n = 00H
TI5n rising edge → TCL5n = 01H
Compare value
CR5n, disable the timer F/F inversion operation, disable timer output.
(TMC5n = 0000××00B × = Don’t care)
Count start
00H
CHAPTER 7 8-BIT TIMER/EVENT COUNTERS 50 AND 51
01H
02H
03H
User’s Manual U16227EJ3V0UD
04H
Note
05H
to 1.
N – 1
N
N
00H
01H
02H
03H