st20-gp1 STMicroelectronics, st20-gp1 Datasheet - Page 12

• Manufacturer Part Number: st20-gp1
• Description: Gps Processor
• Manufacturer: STMicroelectronics

ST20-GP1
as doppler shift, crystal accuracy, etc.). The sum frequency (~8 MHz) is removed by low-pass
filtering in the correlator.
This stage is common to all 12 channels.
Correlation against pseudo-random sequence
The GPS data is transmitted as a spread-spectrum signal (with a bandwidth of about 2 MHz). In
order to recover the data it is necessary to correlate against the same Pseudo-Random Noise
(PRN) signal that was used to transmit the data. The output of the correlator accumulator is
sampled at 264 KHz. The PRN sequences come from the PRN generator.
There is a correlator for the I and Q signals for each of the 12 channels. The output signal is now
narrowband.
Frequency conversion (B)
The second stage of frequency conversion mixes the data with the local oscillator signal generated
by the Numerically Controlled Oscillator (NCO). This signal is locked, under software control, to the
Space Vehicle (SV) frequency and phase to remove the errors and take the frequency and
bandwidth of the data down to 0 and 50 Hz respectively. Filtering to 500 Hz is achieved in
hardware, to 50 Hz in software.
This stage is shared by time division multiplexing between all 12 channels. This is loss-free as the
stage supports 12 channels x 264 KHz, approximately 3 MHz, well within its 16 MHz clock rate.
Result integration
The final stage sums the I and Q values for each channel over a user defined period. In normal
operation, the sampling period is slightly less than the 1ms length of the PRN sequence. This
ensures that no data is lost, although it may mean that some data samples are seen twice — this is
handled (mainly) in software.
The sampling period can also be programmed to be much shorter (i.e. a higher cut-off frequency
for the filter) when the system is trying to find new satellites (‘acquisition mode’).
There are two further stages of buffering for the accumulated 16-bit I and Q values for each
1
channel. These allow for the slightly different time domains involved
.
The results after hardware processing of the signal, using the parameters set in the DSP registers,
refer to Section 3.1, are delivered to the CPU via a DMA engine in packet format. The CPU should
perform an in (input) instruction on the appropriate channel (see address map, Figure 7.1 on
page 47) in order to read a packet.
The format of the 62-byte packets is given in Figure 3.2. These represent a two byte header,
followed by the 16-bit I-values for 12 channels, then the 16-bit Q-values for 12 channels, then the 8-
bit timestamp values for the 12 channels. The I and Q values are sent least significant byte first.
The 2 byte header contains: a ‘sync’ byte with the value #1B, and a ‘sample rate’ byte which
contains the two SampleRate bits from the DSPControl register, see Table 3.1.
Packets are delivered at the rate selected by the DSPControl register, even if new data is not
available. In this case, the data value for the field is set to #8000. This guarantees that synchronism
1. Data sampled in SV time, data transmitted to the CPU at fixed intervals.
12/116