SAK-XC161CJ-16F20F INFINEON [Infineon Technologies AG], SAK-XC161CJ-16F20F Datasheet - Page 56

• Manufacturer Part Number: SAK-XC161CJ-16F20F
• Description: 16-Bi t Single-Chip Microcontroller Preliminary
• Manufacturer: INFINEON [Infineon Technologies AG]

Preliminary
DC Characteristics (cont’d)
(Operating Conditions apply)
Parameter
Level inactive hold current
Level active hold current
XTAL1, XTAL3 input current
Pin capacitance
(digital inputs/outputs)
1)
2)
3)
4)
5)
6)
7)
8)
9)
10)
11)
Data Sheet
Keeping signal levels within the limits specified in this table, ensures operation without overload conditions.
For signal levels outside these specifications, also refer to the specification of the overload current
The maximum deliverable output current of a port driver depends on the selected output driver mode, see
Table
As a rule, with decreasing output current the output levels approach the respective supply level (
V
This specification is not valid for outputs which are switched to open drain mode. In this case the respective
output will float and the voltage results from the external circuitry.
An additional error current (
the definition of the overload coupling factor
This specification is valid during Reset for configuration on RD, WR, EA, PORT0.
The pull-ups on RD and WR (WRL/WRH) are also active during bus hold.
The maximum current may be drawn while the respective signal line remains inactive.
The minimum current must be drawn to drive the respective signal line active.
This specification is valid during Reset for configuration on ALE.
The pull-down on ALE is also active during bus hold.
This specification is valid during Reset for pins P6.4-0, which can act as CS outputs.
The pull-ups on CS outputs are also active during bus hold.
Not 100% tested, guaranteed by design and characterization.
OH
12,
V
DDP
Current Limits for Port Output
). However, only the levels for nominal output currents are guaranteed.
11)
I
10)
INJ
10)
) will flow if an overload current flows through an adjacent pin. Please refer to
1)
Symbol
I
I
I
C
LHI
LHA
IL
IO
7)
8)
Drivers. The limit for pin groups must be respected.
K
CC –
CC –
OV
.
min.
–
-100
52
Limit Values
max.
-10
–
10
20
Unit Test Condition
pF
Electrical Parameters
A
A
A
V
0.5
V
0 V <
OUT
OUT
Derivatives
V1.0, 2002-03
V
=
= 0.45 V
V
DDP
IN
V
I
XC161
<
OV
OL
V
.
DDI
V
SS
,