SAK-XC2264-56F66L INFINEON [Infineon Technologies AG], SAK-XC2264-56F66L Datasheet - Page 77

• Manufacturer Part Number: SAK-XC2264-56F66L
• Description: 16/32-Bit Single-Chip Microcontroller with 32-Bit Performance
• Manufacturer: INFINEON [Infineon Technologies AG]

Preliminary
4.2.3
The amount of power that is consumed by the XC226x depends on several factors, such
as supply voltage, operating frequency, amount of active circuitry, and operating
temperature. Part of this depends on the device’s activity (switching current), part of this
is independent (leakage current). Therefore, the leakage current must be added to all
other (frequency-dependent) parameters.
For additional information, please refer to
Table 14
Parameter
Supply current caused by
leakage
(DMP_1 powered)
Supply current caused by
leakage
(DMP_1 switched off)
Power supply current
(active) with all peripherals
active and EVVRs on
1) The supply current caused by leakage mainly depends on the junction temperature (see
2) All inputs (including pins configured as inputs) at 0 V to 0.1 V or at
3) The pad supply voltage pins (
Data Sheet
supply voltage. The temperature difference between the junction temperature
T
it must be added to each other power consumption parameter.
pins configured as outputs) disconnected. This parameter is tested at 25 °C and is valid for
by the pin output drivers. A small amount of current is consumed because the drivers’ input stages are
switched.
A
must be taken into account. As this fraction of the supply current does not depend on the device’s activity,
1)
1)
Power Consumption
Power Consumption XC226x (Operating Conditions apply)
V
DDP
Sym-
bol
I
I
I
DDL
DDL
DDP
) provide the input current for the on-chip EVVRs and the current consumed
Min. Typ.
–
–
–
600,000
× e
500,000
× e
10 +
0.6×
Section
75
Values
-α
-α
f
SYS
5.2,
Max.
tbd
tbd
tbd
V
Thermal
XC2000 Family Derivatives
DDP
- 0.1 V to
Unit Note /
mA
µA
mA
T
J
Electrical Parameters
Considerations.
and the ambient temperature
V
XC2267 / XC2264
Test Condition
V
α =
5000 / (273 +
T
V
α =
3000 / (273 +
T
Active Mode
f
DDP
SYS
J
J
DDP
DDP
in [°C]
in [°C]
, all outputs (including
in [MHz]
Figure
=
=
T
V0.1, 2007-02
V
V
J
Draft Version
DDPmax
DDPmax
≥ 25 °C.
12) and the
3)
T
T
2)
2)
J
J
),
),