HD6437101 RENESAS [Renesas Technology Corp], HD6437101 Datasheet - Page 310

• Manufacturer Part Number: HD6437101
• Description: 32-Bit RISC Microcomputer
• Manufacturer: RENESAS [Renesas Technology Corp]

Section 9 Watchdog Timer
9.4
9.4.1
To use the WDT as a watchdog timer, set the WT/IT and TME bits of TCSR to 1. Software must
prevent TCNT overflow by rewriting the TCNT value (normally by writing H'00) before overflow
occurs. No TCNT overflows will occur while the system is operating normally, but if TCNT fails
to be rewritten and overflows occur due to a system crash or the like, a WDTOVF signal is output
externally. The WDTOVF signal can be used to reset the system. The WDTOVF signal is output
for 128 φ clock cycles.
If the RSTE bit in RSTCSR is set to 1, a signal to reset the chip will be generated internally
simultaneous to the WDTOVF signal when TCNT overflows. Either a power-on reset or a manual
reset can be selected by the RSTS bit in RSTCSR. The internal reset signal is output for 512 φ
clock cycles.
When a WDT overflow reset is generated simultaneously with a reset input at the RES pin, the
RES reset takes priority, and the WOVF bit in RSTCSR is cleared to 0.
The following are not initialized by a WDT reset signal:
• POE (port output enable) of MTU registers
• PFC (pin function controller) registers
• I/O port registers
These registers are initialized only by an external power-on reset.
Rev.1.00 Sep. 18, 2008 Page 276 of 522
REJ09B0069-0100
Operation
Watchdog Timer Mode