M1AFS250-FGG256I Actel Corporation, M1AFS250-FGG256I Datasheet - Page 329

• Manufacturer Part Number: M1AFS250-FGG256I
• Description: Actel Fusion Family Of Mixed Signal Fpgas
• Manufacturer: Actel Corporation

Datasheet Categories
Actel Safety Critical, Life Support, and High-Reliability
Applications Policy
Revision
Advance v0.3
(continued)
Categories
In order to provide the latest information to designers, some datasheet parameters are published before
data has been fully characterized from silicon devices. The data provided for a given device, as
highlighted in the
"Preliminary," or "Production." The definitions of these categories are as follows:
Product Brief
The product brief is a summarized version of a datasheet (advance or production) and contains general
product information. This document gives an overview of specific device and family information.
Advance
This version contains initial estimated information based on simulation, other products, devices, or speed
grades. This information can be used as estimates, but not for production. This label only applies to the
DC and Switching Characteristics chapter of the datasheet and will only be used when the data has not
been fully characterized.
Preliminary
The datasheet contains information based on simulation and/or initial characterization. The information is
believed to be correct, but changes are possible.
Unmarked (production)
This version contains information that is considered to be final.
Export Administration Regulations (EAR)
The products described in this document are subject to the Export Administration Regulations (EAR).
They could require an approved export license prior to export from the United States. An export includes
release of product or disclosure of technology to a foreign national inside or outside the United States.
The Actel products described in this advance status document may not have completed Actel’s
qualification process. Actel may amend or enhance products during the product introduction and
qualification process, resulting in changes in device functionality or performance. It is the responsibility of
each customer to ensure the fitness of any Actel product (but especially a new product) for a particular
purpose, including appropriateness for safety-critical, life-support, and other high-reliability applications.
Consult Actel’s Terms and Conditions for specific liability exclusions relating to life-support applications.
A reliability report covering all of Actel’s products is available on the Actel website at
http://www.actel.com/documents/ORT_Report.pdf. Actel also offers a variety of enhanced qualification
and lot acceptance screening procedures. Contact your local Actel sales office for additional reliability
information.
The
The
"256-Pin FBGA" table
"256-Pin FBGA" table
"Fusion Device Status"
for the AFS090 device is new.
for the AFS250 device is new.
table, is designated as either "Product Brief," "Advance,"
R e v i s i o n 1
Changes
Actel Fusion Family of Mixed Signal FPGAs
Page
3-12
3-12
5- 13