ADP5585CP-EVALZ Analog Devices, ADP5585CP-EVALZ Datasheet - Page 19

• Manufacturer Part Number: ADP5585CP-EVALZ
• Description: Interface Development Tools LFCSP Evaluation Board
• Manufacturer: Analog Devices
• Series: ADP5585r

Specifications of ADP5585CP-EVALZ

• Rohs: yes
• Product: Evaluation Boards
• Tool Is For Evaluation Of: ADP5585
• Interface Type: I2C
• Operating Supply Voltage: 1.8 V to 3 V
• Factory Pack Quantity: 1

Data Sheet
DETAILED REGISTER DESCRIPTIONS
Note that N/A throughout this section means not applicable.
Note: All register default to 0000 0000 unless otherwise specified.
ID Register 0x00
Table 7. ID Bit Descriptions
Bit(s)
7 to 4
3 to 0
INT_STATUS Register 0x01
Table 8. INT_STATUS Bit Descriptions
Bit(s)
7 to 5
4
3
2
1
0
1
Status Register 0x02
Table 9. Status Bit Descriptions
Bit(s)
7
6
5
4 to 0
FIFO_1 Register 0x03
Table 10. FIFO_1 Bit Descriptions
Bit(s)
7
6 to 0
Interrupt bits are cleared by writing a 1 to the flag; writing a 0 or reading the flag has no effect.
Bit Name
N/A
LOGIC_INT
N/A
OVERFLOW_INT
GPI_INT
EVENT_INT
Bit Name
N/A
LOGIC_STAT
N/A
EC[4:0]
Bit Name
EVENT1_STATE
EVENT1_IDENTIFIER[6:0]
Bit Name
MAN_ID
REV_ID
Access
Read/write
Read/write
Read/write
Read/write
Access
Read only
Read only
Access
Read only
Read only
Access
Read only
Read only
Description
Reserved.
0 = no interrupt.
1 = interrupt due to a general logic condition.
Reserved.
0 = no interrupt.
1 = interrupt due to an overflow condition.
This bit is not set by a GPI that has been configured to update the FIFO and event count.
This bit cannot be cleared until all GPI_x_INT bits are cleared.
0 = no interrupt.
1 = interrupt due to a general GPI condition.
0 = no interrupt.
1 = interrupt due to key event (press/release), GPI event (GPI programmed for FIFO
updates), or logic event (programmed for FIFO updates).
Description
Reserved.
0 = output from logic block (LY) is low.
1 = output from logic block (LY) is high.
Reserved.
Event count value. Indicates how many events are currently stored on the FIFO.
Description
This bit represents the state of the event that is recorded in the EVENT1_IDENTIFIER[6:0] bit.
For key events from Event 1 to Event 36, use the following settings:
1 = key is pressed.
0 = key is released.
For GPI and logic events from Event 37 to Event 48, use the following settings:
1 = GPI/logic is active.
0 = GPI/logic is inactive.
Active and inactive states for Event 37 to Event 48 are programmable.
Contains the event identifier for the pin. Refer to Table 11.
Rev. C | Page 19 of 40
1
Description
Manufacturer ID, default = 0010
Rev ID
ADP5585