TLE6361G Infineon Technologies, TLE6361G Datasheet - Page 2

• Manufacturer Part Number: TLE6361G
• Description: IC PS SYSTEM MULTI VOLT PDSO-36
• Manufacturer: Infineon Technologies
• Type: Step-Down (Buck)r

Specifications of TLE6361G

• Internal Switch(s): Yes
• Synchronous Rectifier: No
• Number Of Outputs: 4
• Voltage - Output: 5.4 ~ 6.05 V
• Current - Output: 1.5A
• Frequency - Switching: 370kHz
• Voltage - Input: 5.5 ~ 60 V
• Operating Temperature: -40°C ~ 150°C
• Mounting Type: Surface Mount
• Package / Case: DSO-36
• Output Voltage: 5.5 V
• Output Current: 1.5 A
• Input Voltage Max: 60 V
• Maximum Operating Temperature: + 150 C
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Operating Temperature Range: - 40 C to + 150 C
• Output Voltage Tolerance: +/- 10 %
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Power - Output: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: SP000013297; TLE6361GNT; TLE6361GT

TLE 6361 G
1.2
Short functional description
TLE 6361 G
The
is a multi voltage power supply system especially designed for
automotive applications using a standard 12V or 24V battery as well as the new 42V
powernet. The device is intended to supply 32 bit micro-controller systems which require
different supply voltage rails such as 5V, 3.3V and 2.6V. The regulators for external
sensors are also provided.
The TLE 6361 G cascades a Buck converter block with a linear regulator and tracker
block on a single chip to achieve lowest power dissipation thus being able to power the
application even at very high ambient temperatures.
The step-down converter delivers a pre-regulated voltage of 5.5V with a minimum
current capability of 1.5A.
Supplied by this step down converter three low drop linear post-regulators offer 5V, 3.3V,
or 2.6V of output voltages depending on the configuration of the device with current
capabilities of 800mA, 500mA and 350mA.
In addition the inputs of six voltage trackers are connected to the 5.5V bus voltage. Their
outputs follow the main 5V linear regulator (Q_LDO1) with high accuracy and are able to
drive a current of 17mA each. The trackers can be turned on and off individually by a 16
bit serial peripheral interface (SPI). Through this interface also the status information of
each tracker (i.e. short circuit) can be read out.
To monitor the output voltage levels of each of the linear regulators three independent
undervoltage detection circuits are available which can be used to implement the reset
or an early warning function. The supervision of the µC is managed by the SPI-triggered
window watchdog.
For energy saving reasons while the motor is turned off, the TLE 6361 G offers a stand-
by mode, where the quiescent current does not exceed 30µA typically. In this stand-by
mode just the stand-by regulator remains active.
The TLE 6361 G is based on Infineon Power technology SPT  which allows bipolar ,
CMOS and Power DMOS circuitry to be integrated on the same monolithic circuitry.
Data Sheet, Rev. 2.0
2
2005-03-01