Z8FMC160100KIT Zilog, Z8FMC160100KIT Datasheet - Page 143

• Manufacturer Part Number: Z8FMC160100KIT
• Description: KIT DEV FOR Z8 ENCORE Z8FMC16100
• Manufacturer: Zilog
• Series: Z8 Encore! MC™r

Specifications of Z8FMC160100KIT

• Main Purpose: Power Management, Motor Control
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: Z8FMC16100
• Primary Attributes: 3-Ph DC Motors
• Secondary Attributes: Graphic User Interface
• Processor To Be Evaluated: Z8FMC16100
• Data Bus Width: 8 bit
• Interface Type: USB
• For Use With: 269-4664 - KIT ACC OPTO-ISO USB SMART CABLE269-4661 - KIT ACC ETHERNET SMART CABLE269-4539 - KIT ACCESSORY USB SMART CABLE
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 269-3639

Table 70. LIN-UART Mode Select and Status Register (U0MDSTAT)
PS024613-0910
BITS
FIELD
RESET
R/W
ADDR
LIN-UART Mode Select and Status Register
R/W
7
0
The LIN-UART Mode Select and Status register
status bits. A more detailed discussion of each bit follows the table.
MSEL—Mode Select
This R/W field determines which control register is accessed when performing a write or
read to the Uart Control 1 register address. This field also determines which status is
returned in the ModeStatus field when reading this register.
000 = Multiprocessor and normal UART control/status
001 = Noise Filter control/status
010 = LIN Protocol control/status
011–110: reserved
111 = LIN-UART Hardware Revision (allows hardware revision to be read in the Mode
Status field)
Mode Status. This read-only field returns status corresponding to the mode selected by
MSEL
000: Multiprocessor and normal UART mode status =
001: Noise Filter status =
010: LIN mode status =
011–110: reserved =
111: LIN-UART hardware revision
MULTIPROCESSOR Mode Status field (MSEL = 000B)
NE—Noise Event. This bit is asserted if digital noise is detected on the receive data line
while the data is sampled (center of bit time). If this bit is set, it does not mean that the
receive data is corrupted (though it may be in extreme cases), just that one or more of the
noise filter data samples near the center of the bit time did not match the average data
value.
NEWFRM—Status bit denoting the start of a new frame. Reading the LIN-UART Receive
Data register resets this bit to 0.
as follows:
MSEL
R/W
6
0
{0, 0, 0, 0, 0}
R/W
5
0
{NE, RxBreakLength[3:0]}
{NE, 0,0,0,0}
R
4
0
F44H
R
3
0
LIN-UART Mode Select and Status Register
(Table
Z8FMC16100 Series Flash MCU
Mode Status
{NE, 0, 0, NEWFRM, MPRX}
R
2
0
70) contains mode select and
Product Specification
R
1
0
R
0
0
131