DF2265TE13V Renesas Electronics America, DF2265TE13V Datasheet - Page 612

• Manufacturer Part Number: DF2265TE13V
• Description: IC H8S/2265 MCU FLASH 100TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2200r

Specifications of DF2265TE13V

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 13MHz
• Connectivity: I²C, SCI, SmartCard
• Peripherals: LCD, POR, PWM, WDT
• Number Of I /o: 67
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 22 Power-Down Modes
22.2
Medium-Speed Mode
In high-speed mode, when the SCK2 to SCK0 bits in SCKCR are set to 1, the operating mode
changes to medium-speed mode as soon as the current bus cycle ends. In medium-speed mode, the
CPU operates on the operating clock (φ/2, φ/4, φ/8, φ/16, or φ/32) specified by the SCK2 to SCK0
bits. The bus masters other than the CPU (DTC * ) also operate in medium-speed mode.
On-chip peripheral modules other than the bus masters always operate on the high-speed clock (φ).
In medium-speed mode, a bus access is executed in the specified number of states with respect to
the bus master operating clock. For example, if φ/4 is selected as the operating clock, on-chip
memory is accessed in 4 states, and internal I/O registers in 8 states.
Medium-speed mode is cleared by clearing all of bits SCK2 to SCK0 to 0. A transition is made to
high-speed mode and medium-speed mode is cleared at the end of the current bus cycle.
If a SLEEP instruction is executed when the SSBY bit in SBYCR is cleared to 0, and LSON bit in
LPWRCR is cleared to 0, a transition is made to sleep mode. When sleep mode is cleared by an
interrupt, medium-speed mode is restored.
When the SLEEP instruction is executed with the SSBY bit = 1, LSON bit = 0, and PSS bit in
TCSR_1 (WDT_1) = 0, operation shifts to the software standby mode. When software standby
mode is cleared by an external interrupt, medium-speed mode is restored.
When the RES pin is set low and medium-speed mode is cancelled, operation shifts to the reset
state. The same applies in the case of a reset caused by overflow of the watchdog timer.
When the STBY pin is driven low, a transition is made to hardware standby mode.
Figure 22.2 shows the timing for transition to and clearance of medium-speed mode.
Note: * Supported only by the H8S/2268 Group.
Rev. 5.00 Sep. 01, 2009 Page 560 of 656
REJ09B0071-0500