HD6473228F10V Renesas Electronics America, HD6473228F10V Datasheet - Page 229

• Manufacturer Part Number: HD6473228F10V
• Description: MCU 5V 32K,PB-FREE 64-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/325r

Specifications of HD6473228F10V

• Core Processor: H8/300
• Core Size: 8-Bit
• Speed: 10MHz
• Connectivity: SCI, UART/USART
• Number Of I /o: 53
• Program Memory Size: 8KB (8K x 8)
• Program Memory Type: OTP
• Ram Size: 256 x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 64-QFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Data Converters: -
• Peripherals: -

In hardware standby mode there is no additional current dissipation, regardless of the conditions
when hardware standby mode is entered.
12.5 Hardware Standby Mode
12.5.1 Transition to Hardware Standby Mode
Regardless of its current state, the chip enters the hardware standby mode whenever the STBY pin
goes low.
The hardware standby mode reduces power consumption drastically by halting the CPU, stopping
all the functions of the on-chip supporting modules, and placing I/O ports in the high-impedance
state. The registers of the on-chip supporting modules are reset to their initial values. Only the on-
chip RAM is held unchanged, provided the minimum necessary voltage supply is maintained (at
least 2V).
Notes: 1. The RAME bit in the system control register should be cleared to 0 before the STBY pin
Note that the H8/300 CPU pre-fetches instructions. If an instruction stored in the last two bytes
of on-chip ROM is executed, the contents of the next two bytes, not in on-chip ROM, will be
fetched as the next instruction.
This problem does not occur in expanded mode when on-chip ROM is disabled (mode 1).
(b) In expanded mode with on-chip ROM enabled (mode 2): when software standby mode is
2. Do not change the inputs at the mode pins (MD
entered by executing an instruction stored in on-chip ROM, after even one instruction not
stored in on-chip ROM has been fetched (e.g. from external memory or on-chip RAM).
goes low, to disable the on-chip RAM during the hardware standby mode.
Be particularly careful not to let both mode pins go low in hardware standby mode, since
that places the chip in PROM mode and increases current drain.
225
1
, MD
0
) during hardware standby mode.