GRM155R60J225ME15D Murata, GRM155R60J225ME15D Datasheet - Page 160

• Manufacturer Part Number: GRM155R60J225ME15D
• Manufacturer: Murata

Specifications of GRM155R60J225ME15D

• Tolerance (+ Or -): 20%
• Voltage: 6.3VDC
• Temp Coeff (dielectric): X5R
• Operating Temp Range: -55C to 85C
• Mounting Style: Surface Mount
• Construction: SMT Chip
• Case Style: Ceramic Chip
• Failure Rate: Not Required
• Wire Form: Not Required
• Product Length (mm): 1mm
• Product Depth (mm): 0.5mm
• Product Height (mm): 0.5mm
• Product Diameter (mm): Not Requiredmm
• Capacitance: 2.2uF
• Package / Case: 0402
• Lead Free Status / RoHS Status: Compliant

8
!Note
• This PDF catalog is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our
• This PDF catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
sales representatives or product engineers before ordering.
!Note
1. Transportation
158
Notice
Notice
Others
1. The performance of a capacitor may be affected by the
conditions during transportation.
1-1. The capacitors shall be protected against
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
excessive temperature, humidity and mechanical
force during transportation.
(1) Climatic condition
(2) Mechanical condition
• low air temperature: -40 C
• change of temperature air/air: -25 C/+25 C
• low air pressure: 30 kPa
• change of air pressure: 6 kPa/min.
Transportation shall be done in such a way that
the boxes are not deformed and forces are not
directly passed on to the inner packaging.
1-2. Do not apply excessive vibration, shock, and
1-3. Do not use a capacitor to which excessive shock
pressure to the capacitor.
(1) When excessive mechanical shock or pressure
(2) When a sharp edge of an air driver, a soldering
was applied by dropping, etc.
The capacitor dropped accidentally during
processing may be damaged.
is applied to a capacitor, chipping or cracking
may occur in the ceramic body of the capacitor.
iron, tweezers, a chassis, etc. impacts strongly
on the surface of capacitor, the capacitor may
crack and short-circuit.
C02E.pdf
09.9.18