WM9713LGEFL/RV Wolfson Microelectronics, WM9713LGEFL/RV Datasheet - Page 54

• Manufacturer Part Number: WM9713LGEFL/RV
• Description: Audio CODECs Stereo AC'97 CODEC T/P Interface
• Manufacturer: Wolfson Microelectronics

Specifications of WM9713LGEFL/RV

• Number Of Adc Inputs: 1
• Number Of Dac Outputs: 1
• Conversion Rate: 8 KSPs
• Interface Type: AC97
• Resolution: 12 bit
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Package / Case: QFN-48
• Minimum Operating Temperature: - 25 C
• Number Of Channels: 1 ADC, 1 DAC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

WM9713L
MONO MIXER
MIXER OUTPUT INVERTERS
w
The mono mixer drives the MONO pin. The following signals can be mixed into MONO:
In a typical smartphone application, the MONO signal is a mix of the amplified microphone signal
(possibly with Automatic Gain Control) and (if enabled) an audio playback signal from the stereo
DAC or the auxiliary DAC.
Note that when selected the stereo input pairs LINEL/R and DACL/R are summed and attenuated by
-6dB so that 0dBFS signals on each channel sum to give a 0dBFS mono signal.
When not in use the mono mixer can be powered down using the Powerdown register bit MX
(register 3Ch, bit 0).
There are two general purpose mixer output inverters, INV1 and INV2. Each inverter can be selected
to drive HPMIXL, HPMIXR, SPKMIX, MONOMIX or { ( HPMIXL + HPMIXR ) / 2 }. The outputs of the
inverters can be used to generate complimentary signals (to drive BTL configured loads) and to
provide greater flexibility in output driver configurations. INV1 can be selected as the source for
SPKL, MONO and OUT3 and INV2 as the source for SPKR and OUT4.
The input source for each inverter is selected using INV1[2:0] and INV2[2:0] in register 1Eh (see
Table 31). When no input is selected the inverter is powered down.
Table 31 Mixer Inverter Source Select
1Eh
REGISTER
ADDRESS
•
•
•
•
•
•
•
LINEL/R (controlled by register 0Ah, see “Audio Inputs”)
the output of the Record PGA (controlled by register 14h, see “Audio ADC”,
“Record Gain”)
the stereo DAC signal (controlled by register 0Ch, see “Audio DACs”)
the MIC signal (controlled by register 10h, see “Audio Inputs”)
PC_BEEP (controlled by register 16h, see “Audio Inputs”)
the VXDAC signal (controlled by register 18h, see “Audio DACs”)
the AUXDAC signal (controlled by register 12h, see “Auxiliary DAC”)
15:13
12:10
BIT
INV1
INV2
LABEL
000
(no input)
000
(no input)
DEFAULT
INV1 Source Select
000 = No input (tri-stated)
001 = MONOMIX
010 = SPKMIX
011 = HPMIXL
100 = HPMIXR
101 = HPMIXMONO
110 = Reserved
111 = VMID
INV2 Source Select
000 = No input (tri-stated)
001 = MONOMIX
010 = SPKMIX
011 = HPMIXL
100 = HPMIXR
101 = HPMIXMONO
110 = Reserved
111 = VMID
DESCRIPTION
PP Rev 3.2 September 2008
Pre-Production
54