EP4CE55F29C8LN Altera, EP4CE55F29C8LN Datasheet - Page 336

• Manufacturer Part Number: EP4CE55F29C8LN
• Description: IC CYCLONE IV FPGA 55K 780FBGA
• Manufacturer: Altera
• Series: CYCLONE® IV Er

Specifications of EP4CE55F29C8LN

• Number Of Logic Elements/cells: 55856
• Number Of Labs/clbs: 3491
• Total Ram Bits: 2340000
• Number Of I /o: 374
• Voltage - Supply: 0.97 V ~ 1.03 V
• Mounting Type: Surface Mount
• Operating Temperature: 0°C ~ 85°C
• Package / Case: 780-FBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Number Of Gates: -

1–56
Cyclone IV Device Handbook, Volume 2
Figure 1–56
Figure 1–56. Transceiver Configuration in GIGE Mode
When configured in GIGE mode, three encoded comma (/K28.5/) code groups are
transmitted automatically after deassertion of tx_digitalreset and before
transmitting user data on the tx_datain port. This could affect the synchronization
state machine behavior at the receiver.
Depending on when you start transmitting the synchronization sequence, there could
be an even or odd number of encoded data (/Dx.y/) code groups transmitted
between the last of the three automatically sent /K28.5/ code groups and the first
/K28.5/ code group of the synchronization sequence. If there is an even number of
/Dx.y/ code groups received between these two /K28.5/ code groups, the first
/K28.5/ code group of the synchronization sequence begins at an odd code group
boundary. An IEEE802.3-compliant GIGE synchronization state machine treats this as
an error condition and goes into the Loss-of-Sync state.
Figure 1–57
automatically sent /K28.5/ and the first user-sent /K28.5/. The first user-sent
/K28.5/ code group received at an odd code group boundary in cycle n + 3 takes the
receiver synchronization state machine in Loss-of-Sync state. The first
synchronization ordered-set /K28.5/Dx.y/ in cycles n + 3 and n + 4 is discounted and
three additional ordered sets are required for successful synchronization.
Functional Mode
Channel Bonding
Low-Latency PCS
Word Aligner (Pattern Length)
8B/10B Encoder/Decoder
Rate Match FIFO
Byte SERDES
Byte Ordering
FPGA Fabric-to-Transceiver
Interface Width
FPGA Fabric-to-Transceiver
Interface Frequency (MHz)
Data Rate (Gbps)
shows the transceiver configuration in GIGE mode.
shows an example of even numbers of /Dx.y/ between the last
Chapter 1: Cyclone IV Transceivers Architecture
State Machine (7-bit, 10-Bit)
Automatic Synchronization
Disabled
Disabled
Enabled
Enabled
Disabled
GIGE
8-Bit
1.25
125
×1
© December 2010 Altera Corporation
Transceiver Functional Modes