ATmega256RZAV Atmel Corporation, ATmega256RZAV Datasheet - Page 347

• Manufacturer Part Number: ATmega256RZAV
• Manufacturer: Atmel Corporation

Specifications of ATmega256RZAV

• Flash (kbytes): 256 Kbytes
• Max. Operating Frequency: 16 MHz
• Max I/o Pins: 54
• Spi: 3
• Twi (i2c): 1
• Uart: 2
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 15
• Analog Comparators: 1
• Crypto Engine: No
• Sram (kbytes): 8
• Eeprom (bytes): 4096
• Operating Voltage (vcc): 1.8 to 3.6
• Timers: 6
• Frequency Band: 2.4 GHz
• Max Data Rate (mb/s): 0.25
• Antenna Diversity: No
• External Pa Control: No
• Power Output (dbm): 3
• Receiver Sensitivity (dbm): -101
• Receive Current Consumption (ma): 16.0
• Transmit Current Consumption (ma): 17.0
• Link Budget (dbm): 104

30.7.13
30.7.14
30.7.15
2549N–AVR–05/11
Reading the Signature Bytes
Reading the Calibration Byte
Parallel Programming Characteristics
Figure 30-6. Mapping Between BS1, BS2 and the Fuse and Lock Bits During Read
The algorithm for reading the Signature bytes is as follows (refer to
page 341
1. A: Load Command “0000 1000”.
2. B: Load Address Low Byte (0x00 - 0x02).
3. Set OE to “0”, and BS to “0”. The selected Signature byte can now be read at DATA.
4. Set OE to “1”.
The algorithm for reading the Calibration byte is as follows (refer to
page 341
1. A: Load Command “0000 1000”.
2. B: Load Address Low Byte, 0x00.
3. Set OE to “0”, and BS1 to “1”. The Calibration byte can now be read at DATA.
4. Set OE to “1”.
Figure 30-7. Parallel Programming Timing, Including some General Timing Requirements
(DATA, XA0/1, BS1, BS2)
for details on Command and Address loading):
for details on Command and Address loading):
Data & Contol
RDY/BSY
Extended Fuse Byte
PAGEL
Fuse Low Byte
XTAL1
Fuse High Byte
WR
Lock Bits
t
t
BVPH
DVXH
ATmega640/1280/1281/2560/2561
BS2
BS2
t
t
XHXL
PHPL
0
1
0
1
t
t
t
t
XLDX
PLBX
XLWL
PLWL
t
BVWL
BS1
t
WLWH
WLRL
0
1
“Programming the Flash” on
“Programming the Flash” on
DATA
t
WLBX
t
WLRH
347