a25l016m-uf AMIC Technology Corporation, a25l016m-uf Datasheet - Page 31

• Manufacturer Part Number: a25l016m-uf
• Description: 32mbit / 16mbit, Low Voltage, Serial Flash Memory With 100mhz Uniform 4kb Sectors
• Manufacturer: AMIC Technology Corporation

Chip Erase (CE)
The Chip Erase (CE) instruction sets all bits to 1 (FFh). Before
it can be accepted, a Write Enable (WREN) instruction must
previously have been executed. After the Write Enable
(WREN) instruction has been decoded, the device sets the
Write Enable Latch (WEL).
The Chip Erase (CE) instruction is entered by driving Chip
Select (
Data Input (DIO). Chip Select (
entire duration of the sequence.
The instruction sequence is shown in Figure 19. Chip Select
(
code has been latched in, otherwise the Block Erase
Figure 19. Chip Erase (CE) Instruction Sequence
PRELIMINARY
S
) must be driven High after the eighth bit of the instruction
S
) Low, followed by the instruction code on Serial
(January, 2008, Version 0.0)
DIO
C
S
S
) must be driven Low for the
Note: Address bits A23 to A22 are Don’t Care, for A25L032.
Address bits A23 to A21 are Don’t Care, for A25L016.
0
1 2 3
Instruction
30
4 5 6 7
instruction is not executed. As soon as Chip Select (
driven High, the self-timed Chip Erase cycle (whose duration
is t
the Status Register may be read to check the value of the
Write In Progress (WIP) bit. The Write In Progress (WIP) bit is
1 during the self-timed Chip Erase cycle, and is 0 when it is
completed. At some unspecified time before the cycle is
completed, the Write Enable Latch (WEL) bit is reset.
The Chip Erase (CE) instruction is executed only if all Block
Protect (TB, BP2, BP1, BP0) bits are 0. The Chip Erase (CE)
instruction is ignored if one, or more, blocks are protected.
CE
) is initiated. While the Chip Erase cycle is in progress,
A25L032/A25L016 Series
AMIC Technology Corp.
S
) is