at89c51re2-slsem ATMEL Corporation, at89c51re2-slsem Datasheet - Page 38

• Manufacturer Part Number: at89c51re2-slsem
• Description: At89c51re2 8-bit Flash Microcontroller
• Manufacturer: ATMEL Corporation

FSTA Register
38
AT89C51RE2
Table 23. FSTA Register
FSTA Register (S:D3h)
Flash Status Register
Reset Value= ‘R’xxx x000b
Where ‘R’ depends on the reset conditions: If RM0 is executed after Reset R=1, if FM0
is executed after reset R=0
Number
FMR
Bit
6-3
7
7
2
1
0
Mnemonic Description
FLOAD
FBUSY
FMR
FSE
Bit
6
-
-
Flash Movc Redirection
When code is executed from RM0 (and only RM0), this bit allow the MOVC
instruction to be redirected to FM0.
Clear this bit to allow MOVC instruction to read FM0
Set this bit to allow MOVC instruction to read RM0
This bit can be written only from RM0 (on-chip ROM bootloader execution).
unused
Flash sequence error
Set by hardware when the flash activation sequence(MOV FCON 5X and MOV
FCON AX )is not correct (See Error Report Section)
Clear by software or clear by hardware if the last activation sequence was
correct (previous error is canceled)
Flash Columns latch loaded
Set by hardware when the first data is loaded in the column latches.
Clear by hardware when the activation sequence succeded (flash write sucess,
or reset column latch success)
Flash Busy
Set by hardware when programming is in progress.
Clear by hardware when programming is done.
Can not be changed by software.
5
-
4
-
3
-
FSE
2
FLOAD
1
7663B–8051–03/07
FBUSY
0