FAN7930M Fairchild Semiconductor, FAN7930M Datasheet - Page 17

• Manufacturer Part Number: FAN7930M
• Description: IC POWER FACTOR CORR CTRLR 8SOIC
• Manufacturer: Fairchild Semiconductor

Specifications of FAN7930M

• Mode: Critical Conduction (CRM)
• Current - Startup: 120µA
• Voltage - Supply: 13 V ~ 20 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC (3.9mm Width)
• Switching Frequency: 300 KHz
• Maximum Power Dissipation: 195 W
• Maximum Operating Temperature: + 125 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Frequency - Switching: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

© 2010 Fairchild Semiconductor Corporation
FAN7930 • Rev. 1.0.1
PCB Layout Guide
PFC block normally handles high switching current and
the voltage low energy signal path can be affected by
the high energy path. Cautious PCB layout is mandatory
for stable operation.
1.
2.
3.
4.
The gate drive path should be as short as possible.
The closed-loop that starts from the gate driver,
MOSFET gate, and MOSFET source to ground of
PFC controller is recommended as close as
possible. This is also crossing point between power
ground and signal ground. Power ground path from
the bridge diode to the output bulk capacitor should
be short and wide. The sharing position between
power ground and signal ground should be only at
one position to avoid ground loop noise. Signal path
of PFC controller should be short and wide for
external components to contact.
PFC output voltage sensing resistor is normally
high to reduce current consumption. This path can
be affected by external noise. To reduce noise
possibility at the INV pin, a shorter path for output
sensing is recommended. If a shorter path is not
possible, place some dividing resistors between
PFC output and the INV pin — closer to the INV pin
is better. Relative high voltage close to the INV pin
can be helpful.
ZCD path is recommended close to auxiliary
winding from boost inductor and to the ZCD pin. If
that is difficult, place a small capacitor (below 50pF)
to reduce noise.
Switching current sense path should not share with
another path to avoid interference. Some additional
components may be needed to reduce the noise
level applied to the CS pin.
17
5.
A stabilizing capacitor for V
close as possible to the V
difficult, place the SMD capacitor as close to the
corresponding pins as possible.
Figure 42.
Recommended PCB Layout
CC
CC
and ground pins. If it is
is recommended as
www.fairchildsemi.com