MC908AP32CFAE Freescale Semiconductor, MC908AP32CFAE Datasheet - Page 51

• Manufacturer Part Number: MC908AP32CFAE
• Description: IC MCU 32K FLASH 8MHZ 48-LQFP
• Manufacturer: Freescale Semiconductor
• Series: HC08r

Specifications of MC908AP32CFAE

• Core Processor: HC08
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: I²C, IRSCI, SCI, SPI
• Peripherals: LED, LVD, POR, PWM
• Number Of I /o: 32
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 48-LQFP
• Controller Family/series: HC08
• No. Of I/o's: 32
• Ram Memory Size: 2KB
• Cpu Speed: 8MHz
• No. Of Timers: 2
• Embedded Interface Type: I2C, SCI, SPI
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

LVIPWRD — V
LVIREGD — V
SSREC — Short Stop Recovery Bit
STOP — STOP Instruction Enable Bit
COPD — COP Disable Bit
Freescale Semiconductor
LVIPWRD disables the V
LVIREGD disables the V
SSREC enables the CPU to exit stop mode with a delay of 32 ICLK cycles instead of a 4096 ICLK
cycle delay.
STOP enables the STOP instruction.
COPD disables the COP module. (See
1 = V
0 = V
1 = V
0 = V
1 = Stop mode recovery after 32 ICLK cycles
0 = Stop mode recovery after 4096 ICLK cycles
1 = STOP instruction enabled
0 = STOP instruction treated as illegal opcode
1 = COP module disabled
0 = COP module enabled
DD
DD
REG
REG
LVI circuit disabled
LVI circuit enabled
If LVIPWRD=1 and LVIREGD=1, set LVIRSTD=1 before entering stop
mode.
Exiting stop mode by pulling reset will result in the long stop recovery.
If using an external crystal oscillator, do not set the SSREC bit.
When the LVI is disabled in stop mode (LVISTOP=0), the system
stabilization time for long stop recovery (4096 ICLK cycles) gives a delay
longer than the LVI’s turn-on time. There is no period where the MCU is not
protected from a low power condition. However, when using the short stop
recovery configuration option, the 32 ICLK delay is less than the LVI’s
turn-on time and there exists a period in start-up where the LVI is not
protecting the MCU.
REG
DD
LVI circuit disabled
LVI circuit enabled
LVI Circuit Disable Bit
LVI Circuit Disable Bit
REG
DD
LVI circuit. (See
LVI circuit. (See
MC68HC908AP Family Data Sheet, Rev. 4
Chapter 19 Computer Operating Properly
Chapter 20 Low-Voltage Inhibit
NOTE
NOTE
Chapter 20 Low-Voltage Inhibit
Configuration Register 1 (CONFIG1)
(LVI).)
(LVI).)
(COP).)
51